What Have You Done To Your 2nd Gen Tacoma Today?

I used a Lexus valve...I think it's what was specified in the sticky mods thread. Looks the same but flows both ways.

 

EXCELLENT ... wouldn't have it any other way.

 

I'm thinking I should go hit a slot machine and hope for triple 7's!

 

Nope...it's a Camary part.

https://www.tacomaworld.com/threads/diff-breather-mod-for-dummies-pics.15686/

 

I painted mine black before I installed them!

 

I wish I painted mine before install, oh well I'll pull em sometime and get it done

 

Got an alignment. Turns out the alignment tabs on the LCA's are seized up, so that's pretty cool... At least the camber is still within proper spec. Guess it's time for long travel sooner than later!










J/K I'm poor...

 

I thought they looked a little like old cheap Monroe's before hand so that's why I painted them

 

Plastidipped my hood scoop insert.

 

washed it and took it to the dealer for an alignment. they couldn't get the caster numbers i wanted but did the best they could without sacrificing the rest of the alignment. i think 1.6 on the left and 1.2 on the rt. it drives great and nu rubing anywhere so seems good to me

 

Greased the u-joints; glad I did. Rear joint gave a little bubble gum pop as a teeny bit of air was expelled. Feels good now and thanks TW!

 

hey check out this post about the caster, funny I just made it when you wrote this
https://www.tacomaworld.com/threads/name-this-problem.447381/

 

Put on my high clearance rear bumper, most of the clearance gain is from losing the hitch, but clearance is clearance...

Probably gained 6 inches at the back end, not sure about my new departure angle yet.

 

Jumped on the band wagon and slapped her with hand full of Merca!

 

Painted the grill black

 

Where you get them?

 

are those pods held on with zipties? lol

 

http://farnorthbydesign.com

 

Did you paint the center caps or did you buy them? I have been looking for a set for a while.

 

Yup. I had cut out holes in the stock bumper and flush mounted the pods. My plan was to put some tapped holes into the tube bumper and mount the pods between the bars with the flanges on the outside, but it turned out they wouldn't fit that way. I didn't want to leave the wires hanging and the switch useless, so the zip ties will hold until I figure a way to either replace the pods with some kind of single row units that'll fit the space better or else fabricate some real brackets to hold those pods (or maybe just bedliner over the zip ties so they're not as visible...)