What Have You Done To Your 3rd Gen Today?

No cutting on the rear...

 

Yah I'd like to...just not sure where to re-mount it? You got any ideas where it would work best?

 

What temp and time intervals for pulling the headlights apart? Turned out great.
I'm looking to do the same.

 

I did 300F for 10 minutes. First one had to go back in once or twice for 2 minutes a pop because I didn't pull hard enough and it cooled. Second one came apart first shot. Outside of that only other time I put them back in was for 5 minutes uses before sealing to make the housing easier to maneuver.

Hope that helps!

 

JGCHFD - Look for a youngster on a 12" or 18" bike that is missing grips on his/her handlebars.
I had the exact same body work done on my 2012 MGM PreRunner. Turned out to be a young
man living rwo doors down. Parents dis nothing about it. finally used touch-up paint to fix it
myself.

 

Least
expensive quote for body shop repair was $850.00.

 

Law Taco there really isn't much you can do when the culprit is a 10 year old boy
whose parents are living on welfare and have to borrow a pot to pee in! . . .

 

Deep out all the chrome and made a diy no drill front license plate holder.

 

Did you buy online? Link?

 

Ordered off of wet okole main website, took almost a month from the time I ordered them.

 

I did it yesterday but I finally had time to put on my LRT 3/1 lift leveling kit. Wasn't sure how it would look with 265/70/17's but I like it. May get 285's and new wheels but not for a while.

 

Looks good. Did mine yesterday. I did a 3/1 as well with 17" wheels and 275 70 17 KO'2. Went back and forth between 275 or 285 and decided on 275. IMHO these trucks loo great leveled out with a little lift. Now I gotta lose the chrome grille and rear bumper.

 

Nice! If I get aftermarket wheels I'll have to look at 275's. I dipped my sport grille but then I picked up an SR grille to replace it. You could dip the bumper end caps too.

 

I was in the same boat and decided on 275s versus 285

 

Nice work! I assume you bake one light at a time? Bake, pull apart, bake the next and pull apart?

 

Not much done so far, installed the BakFlip Fibermax yesterday. I love the BakFlip products.

 

i know we talked last night about it but here's a link with pics... this should work out best for the both of us...

https://www.tacomaworld.com/threads/camera-relocation-mount-now-available.380998/

and i just found this great write up...

http://americanadventurist.com/foru...oma-backup-camera-relocation-diy-w-pics.3159/

even though its for a 2GEN i'm going to assume the set up is similar if not identical... if you were closer we could get this down to a science lol

 

You are correct

 

I've got a super white OR too, I haven't done new wheels/tires yet and I've been dead set all black rims, probably doing TRD sema. BUT DAMN, those are clean! first ones I've seen that I like that aren't all black, nice choice!