What Have You Done To Your 3rd Gen Today?

It's the second notch from the bottom. The bottom one is zero.

Yes I did measure and it gave me almost exactly an inch of lift in the front.

You won't want to preload the stock coils that much, it will ride like shit from what I have heard. If you are going to do that you should do some OME coils set at zero. Check out this thread, I think he has the setup you would want.
https://www.tacomaworld.com/threads...-16-sr-dcsb-4x4.400243/page-120#post-13120171

 

I've basically decided on the 5100 and OME 888 coils set at zero. Haven't ordered yet so always looking for other ideas.

 

Managed to break one of the small seal pieces that goes in the joins of my factory tonneau on the sides... trying to glue back together but I can't see this holding particularly well. Trying to find any replacements online is a challenge!

 

Did you replace your upper control arms?

 

I got the console cover off of Amazon. I just threw it on. I'm sure if you spent a bit more time you could mold it a bit better. With my Tundra the dogs kept standing on the center console so I figured this would add some protection.

$30 Car Console Covers Plus Handmade in USA Designed for Toyota Tacoma 2005-2023 Neoprene Center Console Auto Armrest Cover Protector Black

https://www.amazon.com/TOYOTA-TACOM...275103-4058752?ie=UTF8&psc=1&ref_=ya_aw_od_pi

 

How are they attached at the lower side?

 

So for the 2016s all of the mounts are attached with a push rivot. Drill a 3/16 hole and then push the rivot in

http://www.redlinetuning.com/mobile/Product.aspx?ProductCode=21-27015-05

 

You get maximum opening as well or does it leave some room to open more?

 

You position it so you can get max or you can leave some room. But instructions say where to put and it maxes them out

 

Very cool thanks!!!

 

Installed OME 887's today and 5100's all around, 2 inch block in rear. OME carrier bearing drop and ready lift drop brackets for sway bar and front differential. Running 285/70/17's on XD series wheels. Had previously installed Clazzio seat covers and with the Rugged Cover hard tonneau got the truck pretty much the way I want it.

 

Pictures?

 

Just put on my 1UP USA quik rack.. The quality and look are top notch. If you are looking for a hitch rack, look no further..

 

How much lift with 887 on the front ?? I hear average is 2"

 

Yes, pictures or it didn't happen

 

Good choice with the black. That looks great!

Be sure not to lower tailgate when the rack is folded up, though. On the 2nd gen the tailgate can be opened with the rack folded, but the 3rd gen tailgate has a deeper curve and will contact the rack.

 

Saw a 50k pro today! No thanks.
I'd buy a Tundra Pro for that money.

 

What lift did you use?

 

I could spend another $17,000 in mods and still be out less money. I guess if I were crazy rich I would own one. Fortunately I am sanely middle class. I would rather keep mine and buy 2 of these. The blue matches my Taco very well and under 10k new.

 

Sad thing is I am handicapped because of 5 foot surgeries. But I still might go test ride one of these Honda 1300 Fury bikes. Every since I saw one it bugs me like a new planned truck mod.