Interior Dome LED Light Kits

I'd like a PM also....

 

I'm going to test fit them for 3rd gen, then we will know for sure lol don't steal my thunder.

 

No thunder stealing here

 

I am interested, do you sell this on eBay or Amazon for ease of transaction purposes yet?


Edit spelling ***

 

Welcome to TW!

 

Installed the kit and everything works/looks great. Thanks!!

 

Just here

 

Anxiously wait. Hopefully mine will be in tomorrow

 

Looking for this full kit for the 3rd gen. Thanks!

 

We're working on it right now. Have a fellow member getting ready to try a fitting for us to see if the kit we put together will light your 3rd gens! Stay tuned!

 

Could you add me to that master contact sheet you've got going for when it's finished?

 

Installed mine yesterday and they look great.
My tips...
Vanity Mirror (Sunvisor) lights: use a small screwdriver inserting on the ouside edge and GENTLY pry and it pops right off. There is a small ended on the inside edge to put the screwdriver but it would not work for me. Remove the factory light with a pic, grabbing behind the top of the metal conector. Install the LED. There is no polarity issue here or I just got lucky. Be sure to slightly rotate the bulb inward towards your face so the light shines on it. If you put it straight in the light does not light up your face evenly it points kind of past you. Replace lense inside tabs first pressing gently.
DOME LIGHT: I used the Screwdriver to pry open the lense in the designated spot and then used the pick in a slide and pull motion to get it off. Remove the factory bulb. Insert the LED bulb with the lights pointing down into the truck with the majority of the small holes towards the front of the truck. This will make sense when you look at the bulb. Replace the cover in reverse of removal.
MAP Lights: I believe this is where most people are having problems blowing fuses. Use the Pick to remove the lenses as shown in the video on page 9 of this thread. Push the pick into the lense notch rotate and pull. Then do the slide and pull method to finish removing it. Use the pick to remove the bulk by prying and pulling on the bulb at its base. It is a bit stiff but be patient and try to catch it. The first reason people are blowing fuses is the prongs in the base of the outlet need to be slightly bent back into position so the new bulb is secure. They can get bent open too wide when the factory bulb is removed causing a bad conection when the new bulb is put in. This next move is VERY IMPORTANT. The Map bulb has a + and a - side. INSTALL THE + SIDE SO THE + IS FACING TOWARDS THE DOORS OF THE TRUCK. The - will face towards the center of the truck. Replace the lense in reverse.
I did blow a fuse when installing the map light and I am sure I had the - side of the buld facing out instead of in. I may have gotten lucky on the rest but this is how I did it.
I hope this helps. Good luck and enjoy the bright light. Is very nice and we'll worth it.

 

Thanks for your post and tips. Believe i'll post it on the original post for future people! Enjoy your lights and thanks for the great feedback!

 

I'll need this in a few days. Lol thanks in advance

 

Do you have these for a 1st gen?

 

Unfortunately no

 

Great news for all 3rd Gen owners! We are almost ready to offer 3rd Gen Tacoma Kits!! Stay tuned for updates!

 

Teaser 3rd gen

 

I would like to order a set

 

PM Sent