What Have You Done To Your 2nd Gen Tacoma Today?

I'd say so

 

Yesterday. I went wheeling with a few friends from Tacoma World! Vids by @DoubleRGirl
https://youtu.be/CHJiYv8gI4Q

Then we found a new Jeep that was stuck and pulled him out
https://youtu.be/nS-398G83cs

 

Cleaned and inspected Rear Brakes. Everything looked Good. Used the 12mm Bolts that Hold the factory Front Skid to remove the Drums.

 

Looks good. I might have to look into this. My factory tailgate plastic cap is almost been ripped off.

 

SpiderTrax recommends the thread locker and supplies it in the kit. Seems they thinks it's needed.

 

I had a Mobtown one and loved it! The Relentless one is good too, but if I didn't buy it from a friend I couldn't justify the cost haha.

 

Took a drive around the local lake and mountains around sunset.

 

I hear ya. I just refastened the plastic on. I'll leave it until it's completely ripped off

 

Finally took the 5 minutes I needed to get rid of my rubbing in reverse. I'm running 265/70r17s on a 2"ish lift and the rubbing started after removing my sway bar (I guess it also allows from front to back movement as well). Well either way, it was rubbing on the little nubs that stick out on the inner fender well plastic and I took a heat gun to it to flatten them down a bit.

 

Wheels.

 

Had a busy past few weeks. Wicked Flow muffler came in and turned out to be louder than I expected. So I went ahead and did the dreaded sound deadening project. Noico heat insulation and sound deadening mats. Definitely worth the time and money, truck is so much quieter and feels/rides smoother...

 

Took it to the lake

 

With temperature nearing 70 today....gave the Green Bean a bath.

 

Diff diaper picked up!

 

Looking good!

 

You have a sound clip? Do you have headers &/or intake?

 

LCE Headers, K&N CAI, and a wicked flow muffler. Now with the muffler on, it sounds sharp and ricey... I know a 4 cyl is a 4 cyl and there's not much I can do to improve the sound. However I do want to either quiet it down some, or just go with a new catback. Any suggestions guys?

https://youtu.be/3tBCgeOOtXM