Show your 2nd gen Tacoma on 16's

Only in reverse when turning sharp. No rub at turning while moving forward.

 

2007, all stock except 265/75/16 Cooper A/T3's

 

16x8 -25 FN 5 star wheel
BFG A/T 265 75 r16
Spidertrax Spacers
Billy 5100 @ 2.5

 

How's your rub? I have fn fivestars -25 and 285s i needed spindles to make it work, no amount of lift would help. I like it though. I was going to get spindles anyway.

 

I believe on the 12-15 model years you can remove the lower portion of the fender liner. My 07 is all one piece so I would have to cut, which I will not do. That's why I went with the 265.
I was thinking of trying a heatgun and then seeing if it was possible to reshape the small bump out where I have rubbing issues in reverse.

 

With spindles I still hit the front of the flares on the bumper area due to the offset of my wheels and 285. I still rub but only on platic after the cmc. You won't hurt anything by trimming the plastic a little...

 

In my build thread, which is at the bottom of my post, you can see the pictures of the plastic cutting that is required. I got it below, thought I had posted more pictures of what I cut.

"I have also removed my front mud flaps and cut and zip tied my inner fenders to keep them from rubbing.

 

I have to remove mudflaps and trim about an inch off the inner fender and doesn't rub at all after.

 

Nice setup! I see that you have 285s on the trail team wheels. Does that combo clear your UCAs? Or did you need wheel spacers?

 

I have to run spacers but not for the uca. The lca has a secondary shock mount that will hit the inside of the tire at full lock. This is per the mfg.

 

this picture shows the tab I mentioned
Bottom left of photo

 

IMG_2740-2 by yooitsjeff, on FlickrIMG_2740-2 by yooitsjeff, on Flickr

 

sorry for the delay.

Work pretty well actually, not the running boards get dirty as hell - but stops rocks from dinging the lower panels. I personally want to remove them, but they do a good job protecting the paint.

 

What suspension are you running I like!

 

Thank you. This was on 5100's with 885x's and the rear was just a wheelers 3 leaf aal. Now I'm on icon extended travel, SPC uca's and deaver u402 on the rear

 

How did you get the center caps to fit on the hub? I just ordered pro comp 5001 and the center cap wont fit

 

I like the old school cap. Something you had off another truck?

 

Thank you - it probably isn't really made for tacomas because it doesn't match the taper of the bedsides. A backyard dealer put it on Craigslist and I got it a few hours after he posted the ad - he was a character, he had me digging through hundreds of keys in buckets to find some that fit the locks, but he said I'd find a couple and I did.

It definitely has character lol. I like that all the windows open to give access from each side, but I need to do some weather proofing. Luckily it doesn't rain much here. I guess it could have been made to fit a Chevy or Ranger? There's no name brand anywhere and I haven't seen another like it so I'm not sure.