What have you done to your Tacoma today? 1st Gen Edition

Bogs AF.

 

Hey Totes, I no longer ride, but sprint raced 750 suzuki and endurenced raced yamaha 1000. If I want to ride, I can go to the speed shop and use any bike available which are many lol. I have done over 200mph measured with GPS under seat and speed gun thru a trap. We use to test our bikes on the highway around 2am with highway patrol lol.

 

I was curious too since I didn't pull the truck out till after dark. It's dusty as hell now, neighbor decided to mow his leaves. I think it look pretty good and should hold up well through the winter

 

Yeah, love the color and the look.

I hope it holds up for ya. That would be my only concern.

 

Changed oil in motor, tranny, transfer case, and both diffs. Timing belt coming up soon!

 

If highway patrol caught me going that fast I would never ride again lol. Not that my bike would even go that fast.

Holy shit. How many cans of plasti dip did that take? Nice job.

 

Purchased 3 gallons for it. S

 

For all you guys out there with RTT. I'm getting a custom rack built to fit around my topper, I have the option to do either steel or aluminum. I have OME sport nitrochargers and Dakar leafs with rake and an AAL. If I were to go steel would it be too much weight? With Aluminum its close to 30% less weight, but I feel that I'd like the extra with to bog down the ass end a little. I plan on in the future doing a rear swingout, so I'm taking that into consideration as well. I like to see if you guys have any feedback on what you feel would be best as far as Aluminum vs. Steel. As well as your thoughts on Air bags for the rear. Looking forward to seeing what all your thoughts are!

 

Did an oil change. OEM filter and Mobil 1, as always. Good to go for the Winter

But I did notice that the filter they gave me this time is shorter. I recall reading that there are two filters that can get used. I'll have to specify the taller one, by part number, next time.

 

Pulled out my 881/ 5100s and put in my 883s with Nitrochargers and went to test them out. Way better

 

Just finished taking out the starter to replace the contacts... did that and put it back in. Cranked good and but started up kinda groggy... drove around a bit so the ecu could reset and works like a champ again.

Also added the BVP bracket

Side note: With the total chaos coil bucket gussets makes it a B*TCH to access and take out the starter

 

Played a bit


And decided to sell her



For a good reason...yall will see

 

Did you get your shoes wet getting out to take that pic?

 

Not drunk enough to slip. So no....boots are dry...lol

 

I don't know who you are anymore man!

 

You will love me after

 

No I won't. Even if what you're alluding to is a sased taco.

 

Lol