What Have You Done To Your 3rd Gen Today?

Has anyone removed their Qi Charger to fit a radio? If so, do you have pics/how to? Thank you!!

 

Installed the passenger side floor mat clips.

 

Need to get those for the passenger and the rear. Where you get them? Do you have a link?

 

I need this.

 

https://www.amazon.com/Carpet-Holders-Sleeves-Premium-Accessories/dp/B012VO5XI6. They are a little loose on the rubber mats, which doesn't really matter. The mat also stays up a bit because the bottom piece that sticks into the carpet, but it looks pretty good and I think will work!

 

I don't think the rear mat slides around so much. I do think that the Weather tech look like they have better coverage and fit than the Toyota version! Oh well.

 

Did mine today also with http://www.ebay.com/itm/VW-FLOOR-MA...-TURN-LOCK-OVAL-HOLE-/171348959983?rmvSB=true

 

How did those work? And do you have the rubber mats?

 

Looks like they would suck down to the carpet better, but does that pointed screw tip go in enough to hold?

 

So far so good. I do have the rubber mats and the pointed tip screws through the carpet. At the top of the screw it has a gap so it's not meant to tighten. It will keep spinning no matter how many times you turn it. The fact that you're not just going to pull it out and the disk having some area for leverage, it looks like it's going to work like a charm.

 

Thanks!

 

Thanks

 

With an 8 and 10 year old they're always out of place in my truck

 

More info. here:

https://www.tacomaworld.com/threads/passenger-floor-mat-keeps-moving.408732/

 

Thanks for the link. Found these on there. Looks like they'd fit the mats tight like oem ones on drivers side.
https://www.ecstuning.com/ES348755/
https://www.ecstuning.com/ES348762/

 

put her up in the air for 1000 mile oil change.. what jackoff @ toyota thought it would be better to use a cartridge filter over a spin on?

 

How is the underside of that Tacoma still so clean?

 

not much mud to go through on my way to home depot & target lol

 

Put them on my passenger matt last week... There's still some wiggle room. People have been using rubber washer or the like the fill in the gap before hammering the two pieces together. I used a couple rubber o-rings, helped a little. Still a lot better than nothing. Doesn't move and looks OEM quality.

 

You have sooooo many buttons there.... Oh, and +1000 points for driving a stick.