Icon Dynamics Stage # Lift Thread

I have plenty of room. What are your alignment and wheel specs?

Actually I'm posting this on facebook in your thread there too.

 

Didn't have keys so I couldn't turn the tires out but take a look at these at least.

Driver


Passenger

 

Which kit are you running and what size tires do you have? I'm running 285/70/17's and everything i've read said there is definitely trimming/cmc needed. My garage is a one car, my old truck (titan)literally wouldn't fit through the door width and height haha. Yeah seems like a lot of people are just cutting them off because they're a pain in the ass to get off.

Nice Allpro makes some good stuff, sliders are next on my list.

 

How much lift are you getting out of the Stage 4? that's what i'm going to be running. And are those Ridge Grapplers in 285/70/17? that's the same set up i've got different rims though. How are you liking it all so far? Also can you post pics of the whole truck, i'd like to see the stance and how it all looks.

 

Here's my truck pre Icon lift. The Icon kit is a little taller. In this pic it was a 2.5 (or a little less) OME kit. Now I have a stage 5 Icon kit and it rubbed like a mother. Now that I got it properly aligned again it doesn't rub.

The tires aren't fully turned here but it's at max flex (one front and one rear were off the ground). Even at full lock flexing like this it still didn't rub.

Maybe I just got lucky. I don't know. All I can say is I didn't trim anything. No cab mount chop (yet) and my 285/75/16's dont rub.

 

Yeah I'm thinking caster is negative (no printout given), paired with factory icon stage 4 settings and slightly larger 285's with the ridge grapplers is causing havoc

 

Can you post or share a pic of your alignment specs please?
The shop I did it at never gave me a printout.

 

That's a good looking set up you've got there. Nice work. Well i'm hoping that i've got the same luck as you and I don't have any rubbing issues...time will tell though

 

Yeah I can grab a pic when I get home.

You should shoot for 2.5 caster, 0 everything else. That's what I did. They got it really close to those numbers.

 

What backspacing on your wheels? That is typically the decider for rubbing.

 

They are method wheels.

16x8, offset 0, backspace 4.5

 

That's probably contributing to you not rubbing and the ray10s rubbing.

 

ray10's are 4.35
@SCSPerformance
Vin have you got any ideas on this lil not fitting portion of the thread here?

 

You might also just need to crank up your coil overs, factory height for icons is notoriously low.

 

I'll have to research it more. Don't know what height to go to.

 

You crank them until the ladies go ooooo

 

I am the lady

 

You win this round

 

But really, for my setup I'm shooting for .75 inches difference between front and back, measuring center of hub to fender. Some people go with fully level, some like rake. I personally want some rake as I haul things sometimes and that will squat the rear.

 

Just finished my stage 4 install with total chaos ucas and boss progressive aal. Will be posting pics hopefully tomorrow