What have you done to your Tacoma today? 1st Gen Edition

So you were using the factory 95-96 ecu all along?

 

I had a 97 and tried a 96.

97 has two ECUs. I had an early one (pre May 97) but the second ones are the boost approved ones.

Hopefully this works. If not.

Igor is getting the damn blower.

 

oil is fine after adjusting the dip stick. Besides needing a full change probably.

 

Drilled and retapped some snapped bolts from when I removed the fender from tubbing and finally pulled the washer res last night. Gonna find a replacement today and install it hopefully.

 

Ive done it. twice. On accident.

Well one time it was my brother.

 

Where will you be when Darwinism strikes

 

Probably on Tacomaworld.

 

Not mine, but my fathers, just did the timing belt and water pump for him on his 02. First one its had, 120k miles. Lower idler pulley had quite a bit of play so replaced that with the one from my truck as well as some new hoses. all in all a productive day I'd say. switched to the pink antifreeze too, thing still had the red stuff.

 

Nice. I'll be getting this done next week.

 

I need to do this soon.





Ordered Out tie rods and LBJs today for Igor. My inners finally shipped after being on back order.

 

Soo clean!

 

Relentless Fab mounts and Amazon light bar 40 in curved

 

Hammered down

 

Sad thing is 2 1/2 years ago he bought it with 67k on it... now that was a clean truck, but now it has replaced his corolla on the 7 day a week 140 mile round trip commute to work. He still trys to keep it clean and keep the road salt off though

 

Bald Mtn 4x4, CA

 

Little exercise in the rain today. The odometer said don't do it, but I drove it anyway.

 

Disabled my ABS. Was a confusing endeavor because the descriptions of how to do it on TW have been relatively vague. Some say pull the little ABS2 fuse, which I do not have or could not find. Others say pull the large 60 AMP fuse that is screwed in from the bottom. Well its kinda not, you need to remove the inner fuse panel from the fuse panel mount. Will do a more complete write up in my build.



Then built my replacement reservoir from a bottle I got at wal mart. Used the method I think @Squeaky Penguin or @alee891 used. Reused all the rubber grommets and shoved it in.

 

Added "raptor" lights and paracord grab handles this weekend.

 

Wow that is sex