My lights don't work...

What did I do wrong?
I grounded the lights.
I sent the light power to the relay (87 pin).
I sent the switch to the relay (86 pin).
I grounded the relay (85 pin).
I sent the relay (30 pin) to my powered aux fuse box.


Am I missing something?
Maybe, how do I make sure the fuse box works?

 

SOS 911

 

420

 

what lights? id take the relay out and just use an inline fuse

 

LED pods from Amazon. They worked, so, I don't know.

 

@GHOST SHIP .. sos

 

take the light off and connect straight to the battery and make sure its not the light thats not broken

 

What is connected to the other side of the switch? You said one side goes to the relay where does the other side go?

 

You need Ignition power to the switch in and out to 87

 

https://www.tacomaworld.com/threads/anthony-y-el-burrito-blanco.372728/page-4#post-13547645

 

By my other post I thought you OK'd the one side.

I wanted power all the time

 

This[https://www.tacomaworld.com/threads/am-i-doing-wiring-this-right-lights.463188/page-2/]

 

So you have battery power to switch in and out to 87?

 

Switch to 86, 86 to fuse box that's to power

 

Anybody?..

 

Why not draw out what you have done so far, you just might answer your own question and/or we can show you where you went wrong.

 

I grounded the lights.
I sent the light power to the relay (87 pin).
I sent the switch to the relay (86 pin).
I grounded the relay (85 pin).
I sent the relay (30 pin) to my powered aux fuse box.

I "basically" followed this: https://www.tacomaworld.com/threads/diy-wiring-after-market-lights.6525/

 

86 is ground and 85 is to switch...well damn. Thanks.

 

Also, my switch is just a basic switch, no illumination. Would it still be both posts to the + terminal?