What Have You Done To Your 2nd Gen Tacoma Today?

Messed around with my craigslist topper today. Added a thick gasket in the front, touched up the paint in a few places, replaced the 3rd brake light and sealed it so no more leaking!, put in new clamps that slide in the bed rails (needed a little grinding on the topper though), and gave the inside a good cleaning!

https://www.youtube.com/watch?v=8DvK7UuUhk8&feature=youtu.be

 

Finally got the rear speakers installed.

 

Ordered old school cup holder.

 

I love mine!

 

I might have to get one myself. I liked that much better in my 06.

 

Does this just fit in place where the rubber ones go? I cant stand the rubber cup holders

 

Indeed. There are "slots" that this basically slides into.

 

Freakin awesome, must get

 

awning

 

New Wheels and Tires! Five Lug Power Haha

 

Nice

 

Just finished 30k checkup

 

What he said. The maintence light is just a timer that turns on 5,000 miles once it's reset. Once it hits 4,500 miles, it'll flash a few times when starting up to let you know it's getting close. Once it stays solid, you've hit that 5,000 mark and it will stay on until reset.

 

New Floormats and door sill protectors



Husky front mudflaps




Back pond got the baby gator mod. He is here for the winter and will probabaly move on. I call him Toecutter

 

Christmas gift number 2 is installed. Wet Okele seat covers with heated option and lumbar support on drivers side. Jury is still out on this upgrade. The seat covers themselves fit like a glove and look pretty good. The heat pads take longer to get going than built-in pads I have used in the past.... But when the fire up they are HOT. The switch is crap.... Huge thick and too far down the wire.... It is so close to the cigarette lighter plug that I have it sitting in the cup holder. The lumbar support us just a blood pressure pump and bulky. The worst part is that I moved my seat during install and can't get comfortable again

 

Installing my Christmas present third break lights reverse lights blinkers and park lights

 

Nice!

 

Is this what I think it is....Will allow you to make cup holders out of the middle compartment just in front of the shifter? Cause I was thinking of 3D printing up some inserts to allow two 32 oz yetis to fit there.

 

Correct. It also opens up.