Maxtrac Spindle Lift for 2nd Gen Prerunners

I am im using bora if i remember correctly 1.25f and 2r. i have 5100s with the toytec coil on the very bottom clip. Tire size is 265/75/16. Front is about 5.5 inches and rear is 2-2.5ish

 

Guilty as charged haha
​

 

Thanks bud!
Now...I just have to finally make it out to a meet ​

 

Anyone know what size spacers would be needed on a 3rd gen to clear the stock trd sport 17" wheels with maxtrac spindles ? Convinced my buddy to get them after he saw my 2nd gen.

 

Do you know the backspace?

It's good he already has a 17" wheel

 

I don't know it. Would be stamped on the inside of the rim?

 

I'm not sure, probably find out on the old Googles.

He might be able to get away with no spacer if it's 4.5 bs or less.

 

He can take one off & measure the backspacing. With the tire on hell need to cut something to fit from lip to lip, you can see here where to measure to.

After that figure out what it will take to be at no more than 4.75, less is ok.

This ^^^^

 

All cast those votes in the vendor of the year final round, Headstrong needs 30 votes to take the lead.

 

We are 28 short right now but it isn't over for another 5 days. It is hard to compete with fabricators because their stuff looks really cool but it takes a lot of knowledge and research to cover the many many brands that we do and know exactly how each will work for the various vehicles and how each of the products will best suit our customers needs and budget.

 

Also if you voted for us in the nomination round, that round is over and the final round has begun. You will have to follow the link and revote.

https://www.tacomaworld.com/threads...ards-vendor-of-the-year.466539/#post-13982770

 

Only 12 away now!

 

I like the idea that they were talking about a couple days ago for next year's awards, separate the fabrication vendors from vendors like you. It really is two different things.

 

I feel like each is in a class all its own. They design their products, source the materials, and weld them together. We have to research the top manufactures, how those products fit on the trucks, and how each one fits the end users needs and lifestyles. We also have to compete with large parts houses on the products for minimal margin. Neither are easy, but they are both very different from one another. We have been developing our own products too, leaf springs and coil springs which is a just the next step in what we hope to offer in the future.

Watched Deadpool btw, and it was soooo funny. By far my favorite Marvel movie.

 

voted!

 

Yeah I agree, that's why I think it would be good to have 2 separate vendor categories.
Told you it was a good movie. Haha
One of my top favorites & like you said my favorite Marvel movie.

 

Marie and the Gang You Have My Vote ! ! !

 

Voted

 

Off the current subject but did anybody else have to install extended wheel studs with maxtrac spindles. My wheels are 4.5 backspacing with 0 offset.

 

No need for extended wheel studs, you reuse your factory hub/bearing assembly. So if the studs work now theyll work after the install.