AZ BS Thread 4.2⁰

using blocks/wood to hold up the body while installing a body lift?

 

Nope. Obviously he is building stilts to balance his truck on

 

Wait...he's not baking a pie?

 

I hope he puts a skirt on it

 

Pie. I like pie

Me too

 

replacing my body mount bushings. Need the block of wood to separate the body from frame. the sliders are custom built, tucked up close. I found a solution tho..

 

How else would he air out his clam swamp.

 

good call. I am using a 4x4 on that brace. should be good. already separated.. workin good so far.

 

Put a channel in that block so that the block hugs the pinch weld and won't fly out.

 

Looks like I'll be joining the AZ possy come May, finally got orders out of NJ.

 

@Islandchick leaves, and we get someone new. Nice and congrats!

 

Cleaning off my desk, I found a gift card to 4wheel parts

Days like this, before kids, I would take a six pack of beer and just go play around Table Mesa Rd, usually would run into a few folks, stop and talk and drink a beer. @llibrm Y U not in AZ so we can go do this?

If tomorrow is going to be like today, I may just do that.

 

DM, was there last from 2009-12.

 

I doubt it has changed much... working with A-10s, Compass Call, AFSOUTH... none of the above?

 

Easy but might have to do alignment if you go to a higher ride height or don't don't mark the cambolts beffor you loosen them. On second thought get an alignment when you are done.

 

A10s this time part of OSS, last time was part of OWS...

Sold my street bike when I got to NJ (drivers here are worse than snowbirds there) and now debating if I should sell my MX bike for a dualsport/enduro (MX track looks sad there, endless trails and a bike to ride on and off road).

 

I'll be back sooner than later. Still need tyres though.

 

That feeling someone likes watching you piss.

 

looks nice