What Have You Done To Your 3rd Gen Today?

Anyone know the bolt pattern for the 3rd gen SR5s wheels? Looking at getting some Fuel wheels and don't know which pattern it is....6x5.5?

 

Found a use for the square hole in the middle council. Needed parts for my brothers Dodge Ram. I told him to buy a Toyota. But, nooooooo...

 

turned it in to get the instrument cluster replaced (dash would reset like once a week) i have a fricken prius v for a loaner for the next week and a half..

 

Did this to mine. Mine was driving me nuts. Changed the cluster. Been great since!

 

Snagged a little better more direct shot of the winch when I got to the office today.

 

And I was going to ask how you fit light bars with the winch...

 

Much Appreciated

 

That my friend is yet another SDHQ thing. Their dual 30" lightbar mount is fantastic! Designed to fit pretty much any lightbar out there and keep them relatively hidden. I did have to trim a bit of the back of my Pro grill to clear the lower Baja Designs OnyX6 Hi-Power but only because that lightbar is pretty damn big.

Better shot of the light bar mount

http://store.sdhqoffroad.com/2016tacomabehind-the-grilledualledbarlightmount.aspx

 

I was getting my leafs and drivers seat replaced while they were doing road tests for my tranny issues and they rented me a Chrysler minivan for a week... Enjoy the Prius, I was the brunt of many jokes.
That minivan will never be the same after we were done with it

 

oh shit ... well all the guys at my work drive trucks so im get clowned on for the prius.

 

OH, no doubt.

 

• Truxedo Titanium Tonneau Cover
• Firestone Air Bags
• Replaced head unit with 7200nex Pioneer
• Pop Lock Tailgate Lock
  
• Step up bumper
• Mud guards
• Black insert letters
• 2016 White double cab long bed sport

 

Frame damage

 

Yeah, frustrating may have been the wrong word but it is just a tad sluggish for my taste. No offense to anyone, just my opinion

 

That spot looks awesome!

 

drop the screws out of the bottom of the liner, one plastic clip in the fender flare, and one tiny plastic clip on the inner wheel well.... then you can just pull the liner out enough. it took me about 30 minutes total start to finish because I was going in blind. so the first side took me about 20 minutes and the 2nd side only took 10 since I knew what I was doing.

 

Step 1: pull the center cap off each wheel (they popped off pretty easily by hand)
Step 2: on the back of the center cap, take a utility knife and stick the blade down between the front and rear of each of the mounting tab points that holds the emblems on and wiggle the blade a little bit
Step 3: take a heat gun or hair dryer and put it on each tab for 15-20 seconds
Step 4: gently press down on the tabs with the blade of a flat head screwdriver

I did exactly this and didnt damage any of the tabs or any of the emblems and they took a little bit, but came right off.

After letting them cool down from the heat gun, I then took windex and cleaned the center cap and then centered and applied the resin decals

then popped the center caps right back on the truck.

I hope this helps!

 

You can get them from my eBay store at tacomavinyldecals.com.

 

Well, I have been chatting with my contact at Airaid today and my truck is going over there tomorrow for a new part that they are about to release... Stay tuned...