What Have You Done To Your 3rd Gen Today?

2017
Quieted the wind noise.
3-M Weatherstrip (comes in black) for the door edge seals and
Restricted the cabin 'vents'.
On my access cab, I cut a couple of (approx) 4x12 inch shapes of 3 inch thick green foam. Then, from under the truck, I worked them up with a stick to cover about the right 3/4 of the driver's side vent and most of the passenger side vent. The vents exit the back of the cab between the cab and the pick up bed. Easy peasy and the noise is significantly reduced. Took about 10 minutes for the foam - more for the 3-M (which needs to go be between the attachment points of the door seal). I hated the noise! Now if the transmission ever gets 'right' I'll be happy with my truck.

 

$1080 shipped from crutchfield with all the factory wiring too hook it up!

 

I did this with Dynomat from the inside, don't try to close 2 doors at the same time though, one won't close all the way

 

Damn... why so much

 

Their normally $1399

 

Yeah, I just kinda figured I'd have to leave a little space open. Much easier to do on the outside and if the air bags go off it can push the foam out... at least that's what i figure!

 

Bamf

 

@Cowpoke here's an inferno

Looking good man

 

Where did you buy the hood decal, and did you install it yourself?

 

That's crazy. If I had money like that I would buy but I couldn't justify spending that much. What is so special about it? And do they have anything similar for around 300?

 

Haven't tried them yet. Are they on the BAMF site for sale?

 

Today I got into a warm truck after work. Yesterday tho...I installed the idatastart 2 way car starter. My first car with one. It was nice to get into a warm truck. 3000 ft range is ligit. The installer saw my dashcam and without asking also hard wired it in. Good service - hellofA product.

 

How do the DuraTracs ride? Noisy?

 

It was already on the truck when I purchased it

 

Looking good. Is that stock suspension? Any rubbing from the Duratracs?

 

You'll prob need 1/2" in the back
If you end up needing ,get this ones ...

 

Pics please. Not exactly sure where this is. Thanks

 

New grill should arrive soon. Want to wash truck but the water freezes in less than 5 minutes

 

That's impossible. Global warming, don't ya know!

 

Btw
By lifting the front 2"
Ur changing the geometry
So might experience a vibration
All u need to do is replace the bearing with a bushing (I can't remember the exact technical name )
And the vibration will go away .
That's what I did