ECGS Bushing replacement tool

absolutely, that's awesome!!! I'll PM you my address and look into what shipping would cost. I'll double that to cover return shipping and can either Paypal you funds or include a check with the return of the tool. Thanks a ton!

 

Unchained whenever you're done I'd love to be next in line. Thank You!

 

I had this tool in my possession for over a year. You would have to pm @99superduty to see who he is sending it to next.

 

It comes in the set of tools I have going around. The box has the removal tool, and driver set to seat the new bushing in

 

How much did Dale's charge?

 

They charge $60 for this?

If someone has one of these tools, and would be willing to send it to me so i could copy it, i could defiantly make/sell them for way less then $60.

 

That is what I used

 

Thanks!

 

Not sure as I did not refill it sorry

 

I'd like to just get the dimensions of the bottom part that pulls the bearing out.

 

If you really want to change the fluid at the same time, you can. You don't have to though.

With the driver's side jacked up not much comes out of the tube. You'd be fine just topping it off. It would take way less than a quart.

 

If you're just topping it off I'd try to use what's already in there. It may not matter and I'm not a chemist, but the additives are likely a little different from brand to brand even if the viscosity isn't.

 

Does someone have the removal tool on hand to pass on a few measurements? How wide is the end that pulls on the bearing itself, also is the tool to install the new bushing a bearing race driver or something else. Most of you replace the factory seal or able to leave it? Going to try and make a tool and if not I'll buy a tool and put it into circulation for anyone to use.

 

Looking at a counter top draw bolt made me think to drag the welder out and fab something to work. 4"x 1.25" overall.

 

Who has the tool I need it after January 30th if possible for the weekend. Got some shop time at a friends

 

I believe @99superduty has it

 

You gonna have it done close to Jan 30 or before?

 

I can't speak for when he will be done, but since I shipped them to him I can say they only delivered just yesterday. Tools had to make a trip from up north

 

My bushing is on the way from ECGS so not this weekend but next I should be able to get this done. I've got one member thats asked for it after me and I'll let him know when I'm done. I'll post who is getting it next and anybody that needs it can contact them.