NJ B.S. Thread

Maybe.
If we get the extended brakes lines installed.

 

Damn.

Threw a P0430 code. Got the same code last year. Changed plugs, cleaned throttle body and MAP and it went away. A year later, today, got this.


What I don't understand is why did I get the Traction, VSC and VSC TRAC warning light to come on at the same time?

Guidance please?

 

What? I read this several times and I think I'm starting to understand.

Last year when I threw the p0430 code, the other 3 didn't light up. What's different about it now?

 

Or give it to me

 

You would have to take the hub off and replace with longer studs. Show us pics of wheels and lugs

 

Remember when your O2 sensor was unplugged and it lit up your dash like a Christmas tree

 

Abs was me

 

I can probably do tomorrow, yea

 

Great. Sounds good.

 

Hey dont forget me

 

Yes to many to list

 

Damn lloyd, is it your thing to get stuck all the time? Lol
So with the new winch setup you won't be able to use with the rear bumper?

 

Thanks Tim. At least someone has my back.

 

It's not small, but Trail Limo FTW

 

Not all the time. LOL. Well, maybe most of the time
We tend to spread the stuck wealth around.
The key thing is that we get stuck in stuff that we know we can recover from.

 

I'm thinking the VSC/TRAC lights are lit up because of the possible change in front end geometry because of the new bumper/winch weight and that I still have the OME 884's? But then, why the CEL P0430 code as well?

I haven't done an alignment yet. Going to install B6112's, Eibach 700# coils and LR UCA's this weekend. Then alignment.


@Crom @Wheelspinner

 

Which code is that?

 

P0430 Catalytic Converter Efficiency below threshold. Bank 2.

 

Could be the rear O2 sensor, as they are what monitor the efficiency of the cats.
Just for kicks do the wire method to reset the VSC

FYI, when my alignment was out of whack after doing my front end, my VSC ligjts was on constantly