Colorado B.S. Thread

My 99 Sierra was the same way.

 

Anybody got some of those suction cups to pop out dents?

 

Per the pics posted, You're fucked, that crease isn't going to pop out with a suction cup or witch craft. Best bet is a dolly and someone to skin it/repaint it.

 

Brandon does work on colfax..

 

Im in need for an LED turn signal light that fits the 01-04 one piece headlight.

 

Not that part, I already got that out. The little circle on the doors. Didn't want to have to remove the door panel again.

 

Try dry ice and a heat gun/hair dryer.

 

Mr Fancy pants is out of state. Now we can all act a fool on here, and go get his truck dirty!

 

We do ours at JAX first Saturday of every month. It is a 3 hour class and cost $99. Regsiter at equip2conceal.com

 

Large glue gun, large glue stick, a pair of vice grips, and a wooden dowel

 

Instead of the dowel, glue a bolt that fits a slide hammer...and to remove the hot glue, use denatured alcohol

 

My buddy did some paintless dent repair. Melt the large glue stick in the middle of the dent. Grab glue stick with vice grips and apply outward pressure while tapping the ridge of the dent with the dowel. Remove glue stick with denatured alcohol when done.

 

Heading south into Texas now. Storm didn't hit Kansas as bad as they thought.

 

And I'm not sure if you saw the mythbusters episode, but putting dimples on a car increased the gas mileage. So you might be onto something.

 

Real men go for speed holes

 

Having messed around with this enough yesterday to find lots of things that don't work and one system that does, I am now a self-proclaimed expert on synthetic winch line splicing

DONT WANT
Duct tape. It doesn't slide nice through the center of the rope
Any kind of pointed fid. It's too easy to "weave" a pointed fid through strands rather than staying nicely in the center of the rope.
A knife. It's a bitch to cut the rope and even the strands for a taper with a knife.

DO WANT
Electrical tape. Low bulk, nice and slippery
1/4" extension. Dull tip, nice and slippery.
Sharp scissors. Cut the stuff much easier.

@thefatkid

My splice kit


Now I just need to put this whole kit in a cordura pouch, then in a Pelican case with foam cutouts, and then bolt it to my swing out for maximum EAF cred.

 

Don't forget the MOLLE panel

 

I hate increased gas mileage! It's not EAF!

 

Thats one the outside of the pelican case to secure the other two spare winch lines in a dynema pouch.