What Have You Done To Your 3rd Gen Today?

It's pretty simple! Don't want to take anything away from @brendanwebster911 though.

I purchased a pre wired kit from him on this thread. Including wiring, switch, and directions all nicely packaged. I decided to put my switch over in that cubby so I added some wire. Really just a couple splices and you're all done. Most time consuming part is removing the trim/stereo head unit.

 

Thank you buddy!

 

On the way to our 20 week ultrasound appointment the wife asked if I could stop and get something cold and sugary to drink. It is supposed to give the little swimmer some energy to kick around. So I got her a chocolate milk and myself a coffee. I jump in the truck and found out what that square cup holder is for!

 

oh your bezels blue can yo take a picture it full screen was thinking of changing my carbon fiber vinyl to blue carbon fiber lol

 

Sure! Have this one from when I did it! I think it looks nice

 

Thanks looks good. I wanted to vinyl it with this

$41 VViViD® XPO Electric Blue 3D Carbon Fiber Vinyl Wrap Roll with Air Release Technology (5ft x 5ft)

https://www.amazon.com/VVIVID-Elect...10846&sr=8-5&keywords=3m+vinyl+wrap+blue&th=1

 

That'd look cool too! I don't trust myself to wrap something like that haha. Main reason why I opted for the paint haha

 

How difficult was it to apply the new TRD bedside decals without bubbles or wrinkles. I have the flat black decals but haven't tried removing the old ones or applying the new ones.

 

I chose a 30 amp breaker for my smaller compressor (Air ride) and an 80 amp breaker for the ARB twin motor compressor. Should definitely do the trick

 

looks awesome!

 

went to Anza this weekend

 

That's not me that you're asking but I can answer haha. I had very few bubbles on mine when I applied and they all went away after a couple weeks with the sun. I had it taped in place and slowly pulled the backing paper away in sections, stopping to push the air out, so you're not getting it trying to lay out flat at once. If that makes sense

 

Slapped the sticker on..maybe it will draw in more new comers..so i can see more posts about telling people to use the search bar

 

Truck looks great!!!

 

Removed the V6 badge on the tailgate, still going back and forth on the Tacoma side emblems, have always debadged in the past but not minding the side emblems so far. Installed the SDHQ dual light bar mount & Baja Designs 30" Onx6 Hi-Power in lower position with mictuning "led light bar" switch in the dash blank. Super happy with the set up, light bar is insanely bright, hard to believe at night how much light it kicks out.

Thank you to @JerryTaco for the advice on the light & guidance over PM during the install. Ordered from SDHQ @tubbsisland

 

Hell yeah dude! Looks great

 

Thanks!

 

What is that across the front of your roof rack?? I like the way that looks

 

probably the yakima fairing he talks about

 

This looks really good. This is pretty close to what I want to do. Were you satisfied with the amount of light that reached the road given the plastic from the grille insert is blocking some of it?