Maxtrac Spindle Lift for 2nd Gen Prerunners

Hopefully soon...

 

Well if you wanna ship them to TN let me know. My maxtrac spindles are comin off here soon but I need factory spindles before that can happen.

 

Why taking them off?

 

Planning on swapping to 4x4

 

If you find some factory's and wanna sell your maxtracs. I'm interested.

 

Do a swap?
​

 

You're only 3.5 hours away. Maybe we could workout a swa

Chad beat me to it^

 

Haha he sure did Hmmm. I'd have to swap coils at the same time. 887s + maxtracs would be a little much cruising home lol

 

I still have my factory coils though so we may be able to work something out. I'd wanna put them back on at the same time as maxtracs ...

 

I would keep those Bilsteins too and put em ok your stock coils. That way you could always bump it up a lil if you wanted (I think you will) and they will ride better.

Then just sell the 887's

 

So problem is I don't have a garage or even a parking lot in Knoxville. It'd have to be a in a random lot, like Walmart. Lol. I've got a garage in the Nashville area but that's 5.5-6 hours for you. I don't have a problem doing it in a Walmart lot, or I could come to you. I've done it before and it isn't hard. As long as you already have extended brake lines it shouldn't take us more than a few hours.

 

Set 5100s at .85 w/ maxtracs on factory coils?

I'd prob have a little bit of bro until I could address the rear...



Giggity....

 

I don't currently have extended lines, but if we end up doing this, I could make that happen before the swap

 

Pm me if you're serious, we can make it happen.

 

OR just leave the Bilstiens on the lowest setting with your stock coils

 

Either way. I've been thinking of spindles for a whiiiiile.

 

I know! You would have to get hardware, brake lines. And honestly may want to paint them too......not sure how many miles or condition on em

 

15k miles, very little rust on top, I didn't paint them when I installed them.

What all hardware are you referring though? If I'm pulling them off and going to stock we could trade out hardware from the trucks.

 

Right on!!! If all works right then I suppose so!

 

Found someone on here selling 1.25" spacers. $100 for all four! Can't wait to get them in. Now I just need the hardware and brake lines. On a side note, the spindles I got look like they were left outside so they're pretty rusty. Might have to soak them in vinegar for a few hours and see if that will work. Once the rust is removed I'll be throwing a few coats of paint on them to make them look nicer.