NJ B.S. Thread

Ryan @Sub-Zero can you text me the address? I'm gonna try to make this work

 

If by some small chance you see @HolyHandGrenade before you come down could you bring my hi lift?

 

Will try

 

Gonna get me a pair of money trees...

 

I'll grab it

 

Awesome, thanks Ryan...

 

Costco has a sale on 3 Amp Battery Tender. It's a great deal.
All charging modes, lead acid/AGM/Gel batteries, 12 and 6 volt.

 

Did the pinch weld mod and got some new eBay lights lol. Also attempted to figure this oil leak out but can't pin point the source, it's dripping a lot of oil, any ideas? Do these pics look normal? I see some seeping from the oil pan where it mates to the block but it's not major, must be on the bottom near the drain somewhere
(I cleaned it off in the pics)
This just started happening recently

 

Ouch. Seems as the oil pan gasket. Did u bang the pinch weld or cut it? Any pics? Gonna try to do this on the weekend if I'm able to get some jackstands.

 

Anyone know the center pin diameter for the Dakar Leafs? I'm guessing 3/8"
Please confirm.

 

I cut a bunch more plastic and then saw It was mostly bent already so I just beat it in more, there was a thicker part that I wanted to also bend in but it wouldn't budge much. Then I just doused it in like 20 coats of paint. 90% sure it'll still rub when it's tucked but I'll just have to dick around with it more when I figure out where.
It's not very clean lol

 

That's not good - you've got a bad pan seal there.

 

The leak coming out of the seal there in the one pic isn't reaching the bottom of the pan, is there 2 seperate pieces of the pan? And the lower portion is leaking? How difficult is it to fix? this is a new motor I just put in like 2 years ago and I've still got the old one so I could just swap pans if it's as easy as that. Not sure why this would suddenly happen though, was fine a week ago

 

Took a couple of pics for you today if it helps. Tires are 265/70s'. It's parked on a little bit of a slope, there's more rake than the pics show.

@04yota I have a pair of stands you can borrow. You know where the house is, let me know.

 

Nice truck!

 

What length should I get for the 3 leaf AAL? And how do I know which spacer I'm going to need?

 

the 3 leaf should come with them, unless you're replacing them or something?

 

Used from @Subway4X4 . He suggested I get the u bolt flip. Which I'm not even sure if that's what I'm looking at here.

 

I'm a dumbass. I found the kit I need. Still not sure of the spacer though.

 

you're flipping the U-bolts? And what spacer?