What Have You Done To Your 3rd Gen Today?

basically adding 1-2 inches in just the front suspension usually a spacer to level out the rake of the truck.

 

I just did an eBay level kit yes it's 3/2 from All Roads INC? It's made in 'Mercia and well it's only temporary because I had my wheels first and was super anxious to install asap so I just did this cheap for $149 shipped! If you're interested

https://www.ebay.com/itm/281057649067

 

did u get in aligned ? how did that go any issues ?

 

Hopefully this helps...albeit it looks like a five year old did it. Two pole momentary rocker from Amazon.

Crack open both remotes and locate the button which is soldered to the circuit board (see picture). Flip that over to expose the soldered points. I tested the leads by simply touching a short length of wire until the button 'activates'.

Then solder one point to the first on both remotes. For the middle contact on the switch I just connected both wires together. Since there's no power going through any of them I figured it's safe. I then connected the two spliced wires and the single soldered wire as you see in the paint diagram. If you need more, just let me know, my brain is fried after today.

 

cleaned my windows, detailer did a horrible job at the dealer. I thought the truck kept fogging up but it was really just dirty!

 

Same here i drove mine home in rain and they kept fogging up. Insides were all smudged.

 

Didn't even rain. It was just dark and the street lights highlighted the dirty smudges. I hate nothing more than smudged up glass..

 

Nice! Boy is that remote old school with dip switches no less!

 

Color matched all of my interior gunmetal pieces to Super White (040). Also bought the red push button start.

 

Looks badass man!

 

Just bought one! Can't wait to install!

 

Looks awesome, did you spray it or vinyl wrap it?

 

He listed a Paint code, so I would expect this is a spray job. Super White (040)

 

Correct, I took all the pieces apart and dropped them off with a buddy of mine who is an automotive painter. Gave him the color code for him to spray and clear. The only difficult pieces were the door control pieces because the gunmetal trim doesn't actually separate like the others. He had to mask off the controls as to not bleed over

 

Just don't yank your mirror off like I did and bust your windshield.

I honestly think removing the upper console and manipulating the headliner from above might be your best bet if you absolutely don't want to damage anything, but I managed to make it fit fine without. What are you hanging on your ram mount?

 

You will be happy with it

 

Installation tips???

 

Don't break it

 

Yeah, that much I got!

 

Fak!
That looks amazing !