ETxTacoma's Dynatrac ProRock 60 Rear Build and BS Thread

Nooooooooooooooooooo

 

@Jamart5

Found that Camera?

 

Sorry man got busy with kids and forgot I'll look for it today.

 

All good man!

Just let me know!

 

New license plates are in! Going to go pick them up at lunch! Hell yea!

 

I like that camping emblem... i may have to get one for myself

 

I do to! Thought it was pretty cool with the colors and the campfire.

I will post a pic of it once I get it on the truck, need to figure out a way to put it on the front of the truck...

 

black zip ties

if you use bolts make sure the heads are round to prevent shearing off if you hit the front

 

But where at on the front?

On the bumper or just ziptie it to the grill?

 

If I were you I'd use some magnets on the bumper or zip tie to the existing winch cutouts.

I use something like this

$31 Tuffy Flip-Up License Plate Holder - Hawse Fairlead

https://www.amazon.com/gp/product/B01N4AKOEB/ref=oh_aui_detailpage_o07_s01?ie=UTF8&psc=1

I know it doesn't help you now while you don't have a winch, but you can keep it in mind for when that time comes.

 

I am pretty sure I have to drop the IFS to get my hand back there... need to look again though

 

You can take off the grille to reach down in there. That's a lot easier that messing with the skid.

 

Did not see a way to get down to the actual license plate holes though, I can get to the winch area easily, just not below that.

 

Use The 2 holes where the fair lead attaches to the bumper. Put 2 bolts threw it and I'd they are too far apart get some cheap flat bar and adjust it to the plate holes.

 

Oh, so the winch plate on that bumper is in the way. Bummer...

 

I have the top of mine tucked behind my fairlead and the bottom secured by self-tapping screws.

 

Yea, may see if that would work, may also see if I can get behind there and install it, would rather it be on the correct holes and down and out of the way.

Yep, the winch plate is in the way, I did not notice it until the bumper was on the truck.

Would not be hard to drop the IFS I think to do it.

Yea, I don't want to drill holes in the bumper.

 

Holes already exist?

They make threaded plastic inserts similar to the ones for Sheetrock, that pop into the holes, and then use their screws to fasten it.

 

Mhmmmm that may work actually. Will look at it again tonight and see, may not have looked enough and I bet I can get my hand back there enough to get two bolts done.