What Have You Done To Your 3rd Gen Today?

Can you still see the small blue light (the half arc) just above the knows with these?

 

yes, these new knobs (I have some and love them) actually are a tad bit smaller I think than the original knobs.

 

and added a black door badge. very nice

 

I also couldn't find a reliable reference for the screen dimensions so I tried a bunch of resolutions and watched for letterboxing. I ended up with 885x530.

 

I read on a different thread 885x530. Thats what I used and it worked great

 

Get back in your uniform cupcake.

 

Alright, I installed my Hypertech Speedometer Calibrator and made a relatively short install video, if anyone is interested. It seems to be working fine -- if anything it's reading 1 mph lower than posted.

It's about 9 minutes of me taking my dash apart and talking at the camera for ya.

https://youtu.be/rx44N8sImFU

 

Thanks for the vid! Just a tip, if you clock the STRG wheel upside down and fully telescoped/ lowered, the trim garnish will come out much easier!

 

Good to know! I'll have to disassemble it a few more times in the near future for some wiring adventures so that's good information.

 

Yeah, minimizes the rubbing of the hard plastics on the textured grained parts and putting lots of little scuffs all over the place. Don't ask me how I found out. LOL..

The upside down wheel offsets the wheel center quite a bit and gives you a lot more room to guide the trim garnish in or out.

 

Didn't do it myself. But had airbags put on. And rails on the cap to get ready for a caprac soon.

 

Got this cool book
After reading through it and seeing the high water hazards on some of the trails I figured I'd finally get around to doing the Diff breather mod. Pretty simple and inexpensive for some piece of mind.

 

Found my fix for my Husky Weatherbeater mats, so the water doesn't run off the side corner anymore LOL. Still prefer these over it weathertech cause they go way higher and protect the whole foot rest unlike weathertechs that only protect half! Simple but effective!

 

I got things......

 

TRD rims are getting put on today

 

Where is the dash cam wired to?

 

To the fuse block under the driver side dash. Ran the wire under the headliner to A-pillar. I just tucked it along the pillar and Door gasket to the dash and then under the dash to the fuse block. Used a fuse tap on one if the fuses that is on when the truck is running. Also put a switch for it in the cubby area because I can't have the cam on at work. But otherwise you can just have it hardwired directly to the cam.

 

Decided to throw on some Rigid lights today

 

Pro grill. Wheels and kbro2s in the AM

 

Start up screen! (I'm British)