What Have You Done To Your 2nd Gen Tacoma Today?

Got some rocky mount bed rail bike fork holder things from @glandnut and some weathertech in channel window deflectors! No pics till sunday.

 

Canadian tire special.

It's hard to see but I split the clamp at the end of the bendy rod thing and zip tied it to the roll bar inside the dash. Motherfucker is solid. Then zip tied inside the top of the trim

Left overs...

 

Bed tie down rings

 

@JdevTac as for the scent in my truck if its been sitting in the sun for a while it has a very mild smell of the stuff. But it goes away or i get used to it. Its uber faint. The only place the scent has the ability to come from is the very edges of the peel and seel and thats all covered up by carpetting anyhow. Im sure itll fade as time goes by.

 

Toyo open country's looking at it to be my next set? Noise and grip wise?

 

Might rub with the 285s

 

I have the at2, it has good grip, and just a mild road noise, got a bit louder in 25k miles but still have ALOT of life left.

 

In my defence i never hear it as im slamming 2 15s on 2k watts so its usually always about 140 or so dbs in the cab as is. Havent used a termlab to check dbs yet

 

Just ordered some new speakers for the front doors, get rid of those things pretending to be speakers with magnets the size of a peanut hehehehe

 

The way olfactory sense works is by detecting change in smells. What you smell as soon as you step into the truck is what it actually smells like. From what I've read the peel and seal doesn't do too well in vertical applications. I'm planning on doing my floor and maybe behind the rear seats with it. Please post updates on this stuff every once in a while.

 

Would it be fender trimming or cab chop? & If cab mounts rub can that be fixed w/ wheel spacers?

 

No, you'll rub the cab mount most likely.

 

Both most likely. And no, wheel spacers make the rubbing worse. Only a CMC will fix it.

 

Youll rub plastic fender & Liner.. Also the cab mount. Wheel spacers will make it worse.. But if you have stock wheels or wheels with 5"-5.5" BS then you'll need wheel spacers anyways in order to run the 285's. You will hit the UCA if you don't.

 

I have 6lug steelies. Fenders should be good. I have mobtown bumper that I'm putting in a week or 2 so the only rubbing issue if I'm understanding correctly is the cab mount? & To what extent would the rub be? Only @ full turn?

 

10.4 , it definetly took care of a good bit of road noises. And alot of the bass rattle. I still need to get 3 doors. And the front half of floor. My fingers got very sore from pressing into the corners and nooks so took a break lol

 

Depends if you have aftermarket wheels or not. Also the backspacing of the aftermarket wheels too.

 

Get a 3" paint roller and a pestle from a pestle and mortar for all the nooks and crannies

 

My headlights were all cracked and foggy so I recently installed these. They're the same style as the stock headlights, but they're sort of "blacked out." They look 100 times better than the stock ones in my opinion. I'm really satisfied with them and I'll probably get the matching fog lights soon.

 

I was using the back end of of my box cutter as it was round smooth plastic. But even that was wearing on my fingers lol