Oregon and Washington BS thread

I do haha. I don't take as many as I used to though.

https://www.instagram.com/p/BQZJtL8gDmf/

 

Nice! Liked a few stuff from your IG.

Brah, that girl that commented on your last video

 

If someone twists my arm I could show up in Portland for a breakfast soon.
Lunch would be in Salem,OR.

So.SEAites

 

I spotted a wrecked taco parked either in a junk yard or something in that nature. It was off of killingsworth close to a stop light. The cross street was 72nd Ave I think. I will double check later when I go back by it. Just thought I would pass the word. Maybe someone could find out who's it is if they needed something. I think it was a 2nd gen. I do not know who's it is or what's wrong with it. Just saw it parked there and it was wrecked.
Confirm it is 72nd Ave cross street.

 

I already did @Nimitz

 

You need another one

 

Nah haha. Still trying to sell my tonneau cover

 

My favorite kick stand.

My buddy Scott was down there as well. He's the one in the kilt.

 

Someday Im going to this!!!

 

When I did my extended rear lines, I had to use 2 power bleeders simultaneously and about 1 1/2 pints of fluid , and finally it burped.

 

You guys have any tips on getting an axle out of the outer cv joint?

I've got my +2 Currie axles in i need out without cutting the axle of course. I've tried the pipe trick till I thought I popped a testicle... still no dice. I'm trying to debate if it's worth the effort to cut my outer knuckle, if it's not stupid harden steel, then proceed to dismantle stuff.

I'm just hoping you guys have found another trick or have a helpful idea.

 

On the knuckle end?

 

Yes.

 

Pentetrating lube and then smack the hell out of it with a hammer

 

The axle has to be pulled out of the knuckle. I can't go in with it?

 

Separate the tie rod end and lower ball joint the knuckle will pull outwards

 

Maybe I miss typed.

I need to remove my axle shaft from the outer cv joint. The joint (knuckle) is a steel cup and thr axle can only go in/out one direction.

 

I'm fairly certain you'll need a press then

Maybe @dakotasyota or @northwesttaco can chime in

 

Well I know the two main ways to remove shafts. Cut em or the pipe trick. Can't cut these as I need em...lol. the pipe trick ain't working, or I'm just a huge pussy and need to keep slamming the pipe down once I set my purse down haha.