What Have You Done To Your 2nd Gen Tacoma Today?

Installed my new Prodigy P3 controller. Took way longer than necessary due to Toyota hiding the plug extremely well
Edit to add new location. I kicked it the first time I set the parking brake when it was below the coin tray.

 

Finally got around to getting my backup camera usable again with the pelfreybilt relocation mount. Pretty easy

 

Yes that seems to be one of the things they're good at!

 

they feel good?

 

Just mine for likes just like @ChadsPride I think for every 1000 likes you give, it's worth 1 TW dollar. Not quite sure if that's the correct exchange rate though.

 

Got replacement Coverking Neosprene Seat Covers and was a bitch installing. Ended up removing front seats to get a better fit. Was a good time to vacuum/clean all those tough to get to areas.

 

The eibach coils with the spacers are a lot lot stiffer. It could be the spacers, but you definitely feel the road.

Set at 1.75



With coils and spacer

 

Getting ready for Rear Diff Fluid change. Ordered Three 1 liter cans
Of LT 75W-85-GL5 Toyota Genuine Diff Gear Oil. Part#

$48 08885-02506 GL-5 75W-85 Differential Gear Oil

08885-02506.

 

I'm also in Kansas City. We should go mall
Crawling.

 

Been there, done that, got reprimanded and @ChadsPride got some height!

 

​

 

Not installed yet (raining) but i got some switches in the mail today. Got 4 but only using one for the "parking brake" signal for my dvd player. Was going to get a ch4x4 switch but decided a micro switch would be better.

 

NFAB steps and @Mobtown Offroad locking bed storage doors.

 

Installed the snorkel last night. Picked up new fender clips and put the flare back on today. Gave the nasty whore a bath.

 

Yeah was going to get the one with the waterfall at first, but the waterfall blends in with the W, so most of the time it looks like ashington to me, which would bother me.

 

I have an A/V plug into my factory radio....not sure if it'll work for you before you put the switch in, but for mine to show I have to press the volume up button on my steering wheel for I think it's five seconds and then poof its there.

 

The few video players I've installed only needed a ground for that sensor to let them work at any time. Is there a reason you're switching it, or does your unit not use a ground for that sensor?

 

I'll shoot you the link when I get home from work or get a second to sit down at a computer and pull up my email. They've got some cool other ones as well.

 

It requires the parking brake signal (ground) to be off then on. The switches are NC, so push to open the circuit then release to close the circuit. If wired straight to ground, it blue screens and says that the parking brake must be activated for the screen to work. Open the circuit then close it again and the screen goes to one saying dont watch a movie while driving and has an accept button on the screen that you have to press to go to the movie.

 

Oooo, I have this happening with my current h/u and was wondering what the work around for it was. Super annoying.

I'm piling my kids in the truck approximately a week from today to take them to Disneyland and having them be able to watch something may be cool... Or not, I'm not exactly sure yet.