LED Fog Lights Special! 15%OFF

Grow up

 

NEVER!!!!!

 

Got mine installed today. Went in without any trouble. A little awkward reaching in behind the bumper, but definitely easier than pulling off wheel liners or pulling the bumper off. Totally plug and play and look great.

 

Second batch shipped. Special closes in 4 hours

 

Got my shipping notice

 

Second batch is out! Third batch will ship next week!

 

Got mine installed. Meh. Good cut off, but I think they're just too high and not really a fog light where they're supposed to be.

Also, I have the adjustment screw in the bumper, but there's no place to screw it into the light itself. Am I missing something? The old/stock fixture the adjustment screw actually screws into the light.

Also add fast shipping and great customer service, though. Maybe one day, one day there will be a true LED fog light for our second gens that will be DOT approved, have excellent cut off, and are low enough to be fogs.

 

didn't you say it was self explanatory?

 

It is self explanatory. However, the light fixture does not receive the adjustment screw. Also notice, I'm not whining about it. I gave an honest review and props to the seller for good customer service.

 

As did I but apparently you view it as whining, which Im going to label your post as whining then hah

 

But anyways yours do seem aimed really high. Did you hear them click in place when you pushed them into the bumper hole ? That adjustment screw should have a block piece that you put on the other side of the fog bracket. And it tightens to itselfdoesn't it ?

 

I'm going to check it again tomorrow in the day light and look at it a bit closer. The Rigid DOT dually's were way brighter, but there was no way to adjust them. I wish Rigid made a 3 inch round fog. I don't like the squares in the round holes. looks stupid.

 

Yeah I put the rigids on my ditch lights and they overpower my headlights and fogs. I had the square pod in the fog spot and that's why I took them out. Didn't like it

 

These won't compare to rigids but I also can't drive with my pods on

 

What year is your Tacoma? ill contact TRS and find out what is the best way to fix this issue.

 

Mine is a 2006, so it should be the same for 2005 - 2011. I actually have brand new adjustment screws...but there's no way for the adjustment screws to screw into the fog housing. The stock fog housings there is a threaded hole where this screw goes into, and this is how they're adjusted.

They (the fog housings) physically snap in fine, on either side of the plastic molding of the bumper.

 

I guess there could be a work around...get a flat washer and a nut and glue that combo to the new housing and do it that way....just don't know why they didn't do this like the factory ones.

 

Hopefully someone chimes in with a solution before I find one

 

Got mine installed. Very Happy, much brighter than factory, I may check out the yellow film to see what I like better.

Thanks

 

This little white threaded piece is what I needed. It's off of the old fogs. Thanks to ColombianTaco for the info!