What have you done to your Tacoma today? 1st Gen Edition

Use the "bump the starter" trick to get it of... I'm not an expert but I think you need a new one.

 

I gotta install one of these fuckers.....

 

It's dirty already

 

Getting ready to do my a haul on my brakes...putting in a new fluid reservoir, fluid, front brakes rotors, calipers, and rear pads and drums...
anyone used these power stops...
https://www.rockauto.com/en/moreinfo.php?pk=3797766&cc=1357589&jnid=518&jpid=4
Also looking into the rear brake disk conversion...any thoughts, anyone done it?

 

Ha I really don't wanna have to its like 250... I need to determine any structural damage to the mounting surface

 

Hehe dont you try and ruin my good time.Its actually not though the suede just isnt all brushed in the same direction so it looks like that

 

Love the look really, but I just know it would be tan again after one trip down a dirt road. A lot of the dust comes in through our vents because we don't have any filter.

 

Yeah, I stood on it all the way to the end.

91 Octane with EGR..has quite a few miles on it too so lobes probably aren't sealing like they used to.

7.65psi is a nice number for a stock pulley!

 

Going to be working on a solution for that pretty soon here. We talked about it in here a bit. Im going to try and retrofit one into the ac intake under the passenger cowl. Just need to do some testing to see how moisture is in that area. Dont want the filter where its going to get moldy.

But theres always going to be dirt I know that. Ill find out how well the dirt vaccums off the dash after I get this princess off the pavement again

 

Today I changed all the brake fluid and bled then brakes, put new fender flare plastic tabs on to hold the flare itself better on the truck, prepped sanded and painted sliders again, checked all nuts/bolts (prep for moab)

Fairly productive

 

Nice. I have my Hertz still in a box... need to order a few more pieces still. Which adapter's did you go with? 6.5" speakers correct? Thanks

I just added the Gentex to my list. Didn't know about the homelink model. Other than the new mount, anything required to run the homelink that you know of?

 

Pricey little bastard. You'd probably be fine running it but I would want to replace it. Check local junkyards? The ones around here never have older Toyota parts.

 

Yeah I still wanna mess around with that. It's just that it's been so damn cold lately. Hit the negatives last night. Not good weather for doing anything with the truck, especially not non-essentials.

 

I agree I'll probably do it once I find one on the cheaper side . I'm sure a 4runner one will work fine

 

How is that on the back. Mine was so close to duckts on the left side that I had to fabricate a custom plug for backup camera. Also stock mounting brackets in 95 Tacoma had different hole locations than modern radios. I drilled maching holes in stock brackets an the doble din fit like from factory. No frames needed.

 

First one up this road in a couple months

 

Yeah I have a 2.2" pulley ready to go on but I'm a little concerned that I'll be pushing like 10 psi and I'll need to do injectors, rail, etc. and tune the crap out of it lol
Are you running a 7th injector setup or a standalone tuner or anything?

 

Drove ol goldy up in the snow, bald tires and all

 

Bald tires are the bestest. They're more gooder on that snow.

 

Lol yes, I'm definitely in need of tires