What Have You Done To Your 2nd Gen Tacoma Today?

I was thinking bout those myself. Then I was gonna modify them to sliders. Let me know how you like the construction of the step itself?

 

oh okay nice, that's just a step up from my stock size. had I known more about tire sizes before I bought my tires I would have also gone a step up haha but oh well. Nice clean rig man! kudos

 

I'm pretty close to adding every time I drive..

 

have u pulled the plugs to find out which cylinder is the lucky one?

 

Well, I finally got Techstream to work on an old notebook and hooked it up.

Very DISAPOINTED with customizable features on my 2015 Taco

 

You are absolutely correct, however there are several ways around it.

 

Washed it when it was a little cold outside, but that's life up here when trying to keep the rust down.



And got my new reverse/anytime rear LED flood lights in. Now to find time to install.

 

Want to sell me your driver's side weather strip?

 

nice! I will be doing the flush mount LED pods as well once the weather allows haha u going to put them in ur rear bumper?

 

Finished the install today! didn't end up getting my hands on any plastic pop rivets. auto parts stores don't carry them and Fastenal isn't open on weekends and by the time I finish work they are closed haha so I ended up just painting aluminum rivets black and I'm really pleased with the outcome.



EDIT: for those looking to do this:
- I drilled out the original rivets with a 13/64'' drill bit.
- Top 2 holes I used 3/16'' Diameter by 13/16'' grip range aluminum rivets with a 10-24 washer on the inside.
-The bottom hole I used 13/16'' diameter by 1/2'' grip range aluminum with washers inside and out.
All painted black, these lengths worked out well to show as little as possible ''poke thru'' behind the mesh.

 

You bet! Another time surfing TW has cost me some money, but can't wait to get them in.Tested them today in the basement. Found a nice wiring set up on here too that im going to do.

 

right on man! ill be doing the same, pretty stoked haha I think it looks pretty bad ass too! mine came with all the wiring harness and relay. The only thing I'm replacing is the crapy little push switch it came with. I will be replacing it with this.

http://your4x4store.com/product/ch4x4-toyota-push-switch-tacoma-rear-lights-symbol/

 

Ill need to build my whole set up, Want to install an aux fuse block and maybe a aux battery too. Just need to do more research. Trying to build mine up for some minor over landing. But being Canadian the stuff is so expensive for us, so it's slow and steady build. Just about to roll 160000kms so its definitely been slow! Nice switch thought, might have to get one for myself!

 

Yessir.. the existing bulbs in the housing do a great job, don't they?

 

I'd put the cheapest oil i could find in it until it's fixed, if it were me. Royal Purple is way too expensive to you run out your tailpipe.

 

Will do.

I'm still on the fence on whether or not to go lettering out or not.

 

Where did you get those lights? I need new fogs for my new mobtown bumper

 

New joint bearings and center bearing. Got rid of the last bit of vibration I had, as well as the squeal that developed last week. Pics of the culprit shown.

 

Having the most difficulty of my life attempting to get my double din to fit with all the damn wires back behind it

 

Finally got an ARE MX cap and ditch lights mounted