What Have You Done To Your 3rd Gen Today?

Nice!! Mine have held up GREAT and I couldn't be happier.. With all the big mods on my truck, the headlights actually get much more attention.

 

ADD TO CART.... Thanks

 

what I've "virtually" done to my 3rd Gen today. Rock slider brackets and front bumper

 

Today I installed my TRD Pro Grille and Shift Knob and my Tacoma Bed Mat, all from Tituswill. Saturday, TRD Matte Wheels and KO2s!

 

Today I got my front windows tinted to match the rears!

 

So my truck got 18+ mpg at first than went to 15-16 than was hanging at 13+.......Till todaynow I got this on a 575 mile trip with a 700lb flat bed trailer load. And it's burnt 3/4 qt of oil. Just got it back in to the dealership they said " we can't find anything wrong". Anyone betting I have one of the first 2017s with a motor warranty. The truck had 2800 miles on it

 

Wish I had the frame hole in the middle of the 4 rivets

 

When doing these lights is it hard to wire it to an empty button slot inside the truck? How did you do yours and do the lights come with a button or a switch?

 

How do you know it burned oil? Did the low oil light come on or did you just check the dipstick after the trip?

 

There is a whole thread on the wiring to do this, best to purchase a good relay from like Opt7, a microtunning switch that connects into your bed light switch light. I have basic automotive electrical experience. Maybe 45m-1h to do the electric for me. Search "30inch lightbar install" or "light bar wiring kits". Tons of info.

 

NEW RADIO KNOBS
Slightly bigger diameter than stock (1.1" opposed to .9" stock) and roughly same depth. Cement gray (look white from camera lighting) slick face with rubber grip ring. Perfect size. Easy grip. Contrast color easy to see in the dark. Install in 1 minute each or less. Under $10 a pair delivered. If I get enough likes I will sell. If not then back to the drawing board. Work sooooo much better than stock dinky slick knobs. At this point I was ready to glue pine cones to my knobs if it made them work better.

 

^why do those remind me of some nintendo video game
As long as the work. Although a darker color would blend a little better IMO

 

OK. Will try for a darker color. And def not from a Nintendo. Phone camera makes them look white but they are actually cement gray.

 

They remind me of furniture sliders you put under your chairs so they slide on carpet.

 

You know it!

 

I drilled a hole in the rubber plug next to the brake master cylinder. I had to de-pin the connector and slide it through then reconnect the clip inside the cab. It's on the button it came with for a short while until I put in my 3 switch panel in. Eventually I want to add ditch lights and wire bed lights to a switch.

 

Insurance guy,
"I didn't know Rolex made a tool bag"

 

Took that thin metal bar off the front of the bed. Using a holesaw cut two holes to line up with recovery tracks. Had to cut a small corner of the board off to clear wheel wells. Drilled small holes in the carriage bolts for locks. Add a couple of caps to cover the holes in the thing metal bar and your set.

 

Now I know what it looks like rolling. LOL