Vent shades

I wanted to remove the "stick-on" vent shades from my truck, does anybody have any suggestions ??
Thanks
Barry

 

They should just pop right off, any residue ca be taken off with Goo Gone.

 

Use fishing line (14 lb Fireline works best) to "saw" through the adhesive strip;
then Goo Gone:

 

heat the adhesive with a hair dryer or heat gun then do the fishing line method that is how i debadged my rig then go gone the remaining gunk

 

Definitely true for the OEM Badges, but I have had 2 sets of the stick on Vent Shades and with a little heat and gentle pulling they come right off. Basically almost leaving no residue. Just a thought.

 

Start slowly and pull them off. 3m tape will pull off too just takes a bit, then clean up with goo gone.

 

Ok

Please proceed.

Let them warm in the sun or with a hair dryer, and pull with steady firm pressure. Use mineral spirits or goo gone to work off the residue.

Replace them with some in channel units, like AVS or WeatherTech

 

Get the AVS in channel. Look great, low profile, easier to install imo

 

I have weathertech in channels. I had them on my 2010 for 4 years and pulled them off and put them on my 2015 when i traded in. Never had any issues and no adhesive to deal with. AWS are also good and probably cost less.

 

Silicone spray and fishing line. I worked for Harley Davidson for a few years, this is what we used to remove the stock bicycle reflectors off the freshly painted metal. It works shockingly well. Give it a quick spray and it will just peel right off.