What Have You Done To Your 3rd Gen Today?

The AT is a solid transmission... the programming however needs some work.

 

Did you have someone do the clear bra strip for you or did you do it yourself? Curious where you sourced it if you did it yourself.

OA

 

I was able to swap out my low beams to 8k hids/ my fogs to Amber LEDs/ swap my grill/ and get me some 17x9 Mayhems in 265/65/17 Wildpeak ATs.. Just waiting to lift it a little. Most likely a 3" leveling kit. What do you all think?

 

I had a local tint shop do it.

 

I'm assuming they're standard for Leer? It's what the shop used when the installed the topper.

 

Added my new Tacomaworld and Tacoma Nation patches.

 

4Runner wheels and new tires

 

I bought mine in September and it was delivered straight from the factory and it needed it so i would definitely check especially if you feel the transmission shifting weird. I had problems when coming to a stop at a red light you would feel it slip out when excelling you could feel it shift and also when putting it in reverse. after the update (thanks to Tacomaworld) its like a whole new truck 100 times better.

 

.
.
.
.
.
.
.
.
.
.
.
.
.
.
.

 

What do I need besides the bed rail? Any brackets? Thanks!

 

Lift tires bumper this past week

 

Was wondering what those would look like. I'm not a fan of the black wheel craze. Those look pretty good!

 

CBI?

 

One last question..you show a 30" light bar on your post but the link goes to a 32"...verifying what size light did you go with? Thanks again!

 

So it is, I should have better read the description of the one I have, I bought it from different company then yours CH4x4. I liked it better cause it actually have a picture of a truck and says "bumper led bar". I can't seem to find same one that would fit the center console. They have one that fits the center console but its just plain led bar switch, akin to yours. Thanks for the info anyway.

So if anybody wants an a CH4x4 led bar switch, pm me your address, I'll send it for free. Its blue and got a graphic of the front of the truck with letters "bumper led bar". And it fits to the left of the truck ONLY for 2012+ Tacomas

 

Yes

 

Yes

 

I did the same thing using this stuff:

3M Scotchgard Bra Paint Protection Bulk Film Roll 3"-by-60"-inches

$17 3M Bra Paint Surface Protection Bulk Film Roll 3"-by-60"-inches

https://www.amazon.com/dp/B00CEGTPHW/ref=cm_sw_r_cp_api_aXA4ybBWD1RNM

Just trim it to width and apply wet.

 

Zoom in on this one. It looks clean and neat, I think. No way these would fit nicely behind this grill anyway.

 

That bumper is badass!