Pic Request - 887 springs installed (suspension picture)

Hey all.

Looking for a picture of your OME 887 springs and bilstien 5100s where the sway bar makes a bend. (Behind the tires)

 

Try changing your title to the thread..! It will generate more response than "pic request".....

 

Didn't even catch that....weird

 

Are you having an issue with yours?

 

Sure am. Can get the spring to not hit the sway bar on the drivers side.

 

Make sure the stops on your sway bar are up against both bushings. When I did my lift the bar slid over towards the passenger side a little. I just gave it a wack with a dead blow hammer on the passenger side.

 

That may just do it. It also may explain why now that the truck was put back to stock it pulls like a bitch to the right....

 

I'll have to take a look. Thanks a lot.

 

No problem. Good luck.

 

Do you happen to have a picture of these bushings and stops on the sway bar? I'm going to reattempt tomorrow

 

https://www.tacomaworld.com/threads/cant-get-caster-into-spec-after-icon-uca-install.409946/

I personally don't have a pic but if you look at post #6 3rd pic the silver ring on the sway bar is what I am referring too. Both sway bar mount bushings should be up against or very close too thoes stops.