What Have You Done To Your 2nd Gen Tacoma Today?

Soooooo clean and so nice

 

Installed Doug Thorley LT headers.... Never doing that again, what a major PITA.

 

How long did it take you? Are you impressed by the gains???

 

Thanks!

 

Replaced the wimpy factory horns with Hella Supertones

 

About 12 hours total from jacking it up to rolling it out of the garage. Absolutely no room to work with as far as torquing header bolts down to the manifold. Some loss of low end torque, haven't hit their sweet spot in high RPMs yet as I'm still breaking in my 4.56 gears. Sounds deeper/throatier for sure.

 

I'm stuck between the URD headers or exhaust lol

 

Neither it's a v6 truck for god sake.

 

Finally got around to doing sound deadened on the roof. One layer of stinger roadkill,one layer of frost king.

 

@Ross09 Where did you get those from and would you happen to have part numbers?

 

Long tubes fo sho

 

Rockauto.com has them for about $30 each side.

 

Dis!
KO off-road

 

Took it to the lake to drink beer!

 

I got it all off of Amazon.
Parts numbers are

$26 K80948 (2) Front Sway Bar Links FITS Toyota Tacoma 2005-15 4X4 & 2WD WITH PRERUNNER K80946 K80948

K80948 for the Left side
K80946 for the right side
Bushings are

$18 K80820 Suspension Stabilizer Bar Bushing Kit for Toyota Tacoma

K80820
Total cost was $76.05
These links have alemite fittings and dont require an allen key to remove/tighten

 

I did that recently as well when I had the headliner out for the prinsu rack install. One layer of dynamat. Did all 4 doors as well (access cab). Makes a world of difference, especially with the radio sound quality. Doesn't do anything for road noise however since it all comes up throught the floor and back wall.

 

I did the doors a few years ago, did the back wall a few months back, did up the firewall as far as I could a few months ago. Now the roof. Eventually pull the carpet and do the 1/3 of the floor that's left. lol

 

Today I eliminated an obnoxious rattle I've had for a couple weeks. Sway bar end links were the culprit. I guess I forgot to torque them down after I did the ecgs bushing install.

 

Did you use the stock wiring or run new?

 

Interior detailed, oil changed and touched up some chips and rust spots.. oh and spilled my dealer touch up pant all over the garage and myself when a bug stung me...