What Have You Done To Your 2nd Gen Tacoma Today?

When running my trucks AC I switch from recirculated air mode to outside air mode periodically as I'm driving. I always put the AC system on outside air when turning off the truck.

 

That was tricky...didn't realize that on the passenger seat but looks okay... the driver seat i.managed to get the rods to catch. Alot of contortions to reach . Honestly the hardest part was doing the headrest covers... I could probably do another set of seats in half the time now...

 

Chad needs a new Avatar

 

It aint mine tho lol​

 

Yet...............

 

Dammit @ChadsPride Not even a minute and you liked it!

The headrests on my 2015 were difficult (front seats) to get on. I couldn't take off the cloth, it was fully glued to the foam. The front headrests on my 2007 worked just like the rear headrests. They changed the shape and size, likely in 2012.

 

PO did, i bought it at 163k a month or so ago lol. he did get oil changes at Toyota like every month an a half.

 

Yeah LEER 100R as confirmed by leer today. No yakima tracks, so I gotta do that myself

 

Thule tracks for 6ft shell, 22$ each from the "spare parts" depts ORS direct, shorter ones are <20$

http://www.orsracksdirect.com/thule-853535903-track-single-part.html

 

Awesome thanks. Did you buy the bolts and hardware there too?

 

Used it to run to Walmart to pick up the oil and filter for the Camry's 80k change. 5qt of 0W-20 was $22.96.

 

Nope, the "kit" from thule comes with a hex wrench and a steep retail markup, better to buy the stuff at the hardware store, save $

 

Awesome. Yeah $55 shipped to my door can't be beat

 

The "end caps" are just a few $ on ors direct as well but I skipped them as they are unnecessary, mostly cosmetic.

 

Yeah I'm going to install the Prinsu Rack eventually anyways so no need for the cosmetic end caps

 

If it takes more than a minute then I start to worry about ChadsPride.

*Edit - 57 seconds on that one Chad, you just made it.

 

Thanks.

 

Finally starting my sound deadening project tonight! (1 door per night) Any wisdom from those that have already done this would be greatly appreciated! Advice I've gotten so far is to wear gloves, be patient, and clean the surfaces well beforehand.

 

Installed 3" Nfab step bars over the weekend. With a lift I always felt I was ruining my seats sliding in and out on them.

 

Applying two coats of Wax to the Roof. This area is important to keep waxed in my Beach environment. There are many local Tacos that have neglected there finish and surface Rust has started !