What Have You Done To Your 3rd Gen Today?

What are you going to do with the stock OEM exhaust tip? If you need someone to take it off your hands I will happily assist.

 

Welcome to the club.

 

ain't pretty, but finally found a way to mount a CB antenna under the softopper without scraping up my tailgate. Mounted to an existing bolt on the side of the bed. Used a zinc plated corner brace from homedepot. Only had to drill a hole for the antenna and trim a little, the other hole matched up perfect to the bolt in the bed.

 

*****************
You mean the intake tip in the fender? When I installed my CAI I used the supplied rubber funnel-like but after a short while I put back the OEM tip since it has better seal and suction.

 

No, I was asking about the stock OEM "exhaust/muffler" tip.

 

Thanks for the info!

 

Happy to help! Good luck!

 

Hey do you mind sending me some pictures of that fender funnel, maybe some measurements or something I could use to scale the images? is it rubber? I would like to try and replicate that part.

 

Laid down some @rrentrop reflective vinyl inlays in some red tailgate piano letters. Ganna let them sit overnight with a book on them and install tomorrow. Should look good with my black and red theme.

 

My OCD just kicked in, in some letters the black inlay is not centered. I.e the O and both A's need to be pushed over to the right a bit

 

Did you have to do any cutting for their bumper? I have my eyes on theirs.

 

yep, but it's literally in the line of the bumper.... here are the installation instructions

 

Good looking.......................... truck.

 

I like how your shorts and her blouse match.

 

Me or the truck? Lol

 

Two peas in a pod. Lol

 

As a follow up

 

DAMN!