What Have You Done To Your 2nd Gen Tacoma Today?

I just put on some LED fog lights for a Lexus IS250. They fit almost perfectly. This is what I used http://www.ebay.com/itm/282458827879.

I'll put up pictures a little later. Small mod but it definitely looks a lot cooler than the stock lights.

 

I still need to adjust the beam down a little bit

 

More pics and install info!

 

Ill take some more and put up more info when take my lunch break

 

The 60" jacks were showing available and in the time it took to go to the site and check, they were gone again.

I have slider adapters for a hi-lift that I got a while ago... Assuming I was going to get the jack eventually.

 

I'm looking into these same wheels. SCS Ray10's are my first choice but I think I want new wheels before the apocalypse...

 

My fault. I might have bought the last one.

 

Haha, you're picking it up all the way over in Chandler, AZ? If you want it that bad then it's yours!

 

I get the impression they are shipping these from a distribution center to the stores. I ordered it this morning but it's not available at the local store until tomorrow afternoon. I think with the nearest DC is out of stock is when they take them off the website.

 

Pep boys near me website.
I'm only seeing the 48" Big Red !
What's the 60" called?

 

The Alabama Hamma

that he will actually type that into the PepBoys search box...

 

That came up with Alabama seat covers !

 

Haven't done much to my truck but I have been working out of the company tacoma the past few days! Loving every minute! Haha

 

He is so adorable!!!

 

Body armor 4x4 plate bumper is fairly cheap and will take on a lot more than a mini van

 

Same here! He's such a lazy bum, which fits my needs perfectly.

It's a tiny little thing but gets the job done! That's why I like it. That sucker gets HOT AS SHIT though. After filling my tires it rides in the bed until I get home.

Yep, Boogie is right. They're just Lamin-X covers!

 

Not today, but last night: Spent some money with @CBoy808. Pics to follow when the bedside decals arrive.

 

Quote from my build thread. Best way to get the adhesive pads off?

 

Heat and GooGone. I'm sure you could use a tad of gasoline but it looks like you have bare metal there...