What Have You Done To Your 2nd Gen Tacoma Today?

Got the fox shocks installed.

 

If you can't find the information you're looking for, start a new, properly titled thread. That way if someone has the same question down the road, they can find it. Asking in random threads is how useful information gets buried and is impossible to find.

 

Got my gentex 455 mirror wired and connected. Special thanks to @Ironium for the OH consel pics and input in the project

 

Noted, will do... If anyone has any info that they would be generous enough to contribute please do so here:

https://www.tacomaworld.com/threads/winch-synthetic-steel-vs-pull-force-trade-off.492276/

 

Wires are crossed... N=S

Juuuust kidding.

 

Sorry I can't contribute, but I hope someone comes along that can! If you don't get any responses, bump it once a day or so to bring it to the top for more attention.

 

Installed my newly painted hood for my 05 to 12 front end swap. Just need the filler to come in and my slim light bar to fill the gap under the grille.

 

Washed, waxed and installed new bedside decals from @CBoy808

 

The ole Taco is at 172K miles now paint on the hood and roof is looking pretty rough but I got it ready for vacation in a couple weeks. Oil change, rotate and balanced the tires, air filter, cabin filter, cleaned out the whole in side and did a little modification to the storage area under the rear seats. Removed the plastic storage to fit my CZ scorpion carbine. kids have taken their toll on the rear seats need really need to get them detailed but another project for another day.

Scorpion fits real nice under the seats open the rear door flip up the seat bam ready to go

 

Changed the oil, greased all the zerks. Now time to enjoy some well deserved beer

 

What do you all think? Could be useful for a platform or to hang stuff off

 

First the Florida F*@K bugs covered my truck with their guts (the new front paint made them super easy to clean)


After I cleaned the truck, I laid some velcro over the visor safety stickers. Now I can actually used them to hold stuff

 

Pre cut size or what? I like this

 

Installed 2 of these for reverse lights.
https://www.lowes.com/pd/Feit-Elect...n-Appliance-Light-Fixture-Light-Bulb/50109588 - Very noticeable difference, even during the day. Not bad for $6/bulb. Completed install for both in under 15 minutes.

 

Ordered these and cut them down

Mydio 2 Pack 10cm Wide 1 Meter Long Self Adhesive Hook and Loop Strips with Sticky Back Tape Fabric Fastener

https://www.amazon.com/gp/product/B06ZZDNWBL/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1

Still have some extra loop and a whole roll of the hook side.

 

Valve cover gaskets, replaced springs, boots and seal for the ignition coils and changed sparkplugs. Also I steam cleaned my valve cover while I had it off.

 

wheel spacer? no, just the new rotor makes it look like that lol

 

Never powder coat sliders. Self etch primer a few times, and then follow with a few coats of semi-gloss.

 

Wow these are nice! May I ask where you bought them at?

 

I also have a set of AVS and love them. Nice choice.