Northern Virginia Roll Call

my price is high..

https://youtu.be/J4b4QoXEhtA?t=7

 

The oriental flavor...

 

Be careful....high in sodium....

 

@Darkgoatracer this shop looks very familiar to EVW shop.....

https://youtu.be/qFe34wTjwtc?t=238

 

Well shit. I was going to pull the bolt out of the top rear part of my shackle to trim it a bit since it's rubbing the frame, and sure enough the rear bushing part of the dakar popped out of alignment. Short of taking everything apart, does anyone know a creative fix to this shitstorm to get the bushing lined back up so I can slip the bolt back through?

 

If you don't want it I will Grab it from you I was just gonna order some?

 

I am not sure. @DOUBLLD

 

I might try placing my OEM bottle jack ABOVE the dakar bushing to hold it in place, and use my floor jack under the shackle to try to push them together.

 

Looks fun man I need to get a bike to get where my truck can't and just some exploring fun.

 

I don't need two more than welcome. I need to pick up damn fuel line to I can do it.

 

Lmao!

 

And they look good on his truck!

 

Oh guys I just remembered Exotic Vehicle Wraps is doing their 1 year anniversary party at the shop. Cars, wrap demonstrations etc. You guys should swing by. June 25th 10-2. Here's a video of last year's thing.

https://youtu.be/UBQ_alDaonI

 

Sweet I will hit you up this week. Yeah I need to grab the fuel line as well. Sometimes Amazon is just easier cus I order and it shows up. I don't have to Go anywhere lol.

 

Hey when you installed the bedside supports for the d ring what did you put back on. Installing these bitches now

 

I didn't put all the shit that's under the D ring back, just the D ring and bolt

 

He has @Mobtown Offroad sliders I believe

 

@Lots2Learn58 and @ready6delta

Both sides seem to go up at an angle, I tightened the bed bolts down. Bottom is flush with bed but this is what it looks vertical. Driver side then passenger side



Is this fine. Or should I push a little on driver side and drill holes that waywhere it is a little more aligned.

 

I pushed mine over so it was aligned. I drilled the top hole then bolted that down to hold it and drilled the rest

 

So keep bottom tight, push over a little so it is flushed and even top to bottom. Then drill hole at top, put in bolt push bottom and drill in hole? Sound about right?