Maxtrac Spindle Lift for 2nd Gen Prerunners

Heck yes man!!! Suckers are heavy aren't they!

 

You Sir are very welcome And thank you for your business

 

Haha ya they are! Much bigger than I thought, pics don't do em justice. I got everything setup at work for painting them tomorrow, made a nice spot in the shop and hung the hooks so I can get it knocked out, too excited to get em on in a couple/few days!

 

Sweeeeet!!! Clean them up real nice tonight so they can be plenty dry and ready for paint

 

I've been looking into putting maxtrac spindles on my truck for a while now, right now I have just a 2inch leveling kit and I'm running 275/65r18s. Yes I rub a lot considering they're mud terrains and I wanted to lift more to get rid of rubbing and for more clearance. I'm wondering if anyone has 4-6inch of lift with the same or similar size tire. It's about a 32.3" tire by 11"

 

Tons of members with spindle lifts run that size if not larger tires

 

Thank you, anyone have any pictures?

 

Probably just do a google search "maxtrac spindles 2nd gen Tacoma"

Maybe even add the word "TacomaWorld"

 

Here's my old truck on just maxtracs and 285's
And here is it with 3" coils on top of the maxtracs, again on 285's

 

Finally got around to getting some new tires. Went from 285/70 nittos to a 285/75/17 toyo at 2. Fits perfect and didn't have to cut or trim anything with spindles and 5100/884 combo.

 

So 2016 coil overs fit your 2014... Can i assume a 2017 coil over will fit a 2008???

 

Yes, they will provide ~1" lift up front

 

So is this may be a dumb question: but if i have the bilstein 5100's in front and 5160's in rear, set to 3inch in front (2.5" maxed out). if i add these spindles, will it add lift? or just adjust the geometry of the lift?
thanks!

 

You will have 4" on top of what you are running now

not a dumb question at all

 

thanks man! did you have to add sway bar brackets? i figure brake lines is a must..

 

Nah, I just left the sway bar alone.

Extended front brake lines come with the Spindles through @HeadStrong Off-Road

 

Appreciate it! I've only done strut replacement lifts before so this was some new territory. seem's straight forward enough though!

 

Should be able to handle it!

How much lift are you wanting?

You could always go with Maxtracs and drop the bilstiens down to zero for a better ride quality

 

I have essentially a 3 inch, was looking for a 4.5-5 inch for better tire clearance and a bit more of a level.. I have 2.5" spacers i could put on top of the 5100's maxed out and get that effect, but i don't think the geometry would work well, so I'm leaning towards spindles....

 

You could go Maxtracs and 884s with the bilsteins on "0" and be around the 6" range up front

Thats what I'm going to do next

Right now I have the Maxtrac spindles and 2016 TRD OR shocks and coils and those gave me an extra inch