Sandman614's #expoenough Build

Playing with my "new" laptop, here's my Chrome Home Page

 

TPMS sensor replaced, broke it when I blew the bead on a tire at Windrock Trail 12

Edit: Denso 550-0102 fits but is too short for my lock on air chuck.

$33 Denso 550-0104 TPMS Sensor

Denso 550-0104 is correct

 

Soo 3 lights? I got new lights because one of my old halogens was broke at Windrock, damn , lol. Well the replacement halogens I ordered from the same company don't match..


*finger was intentional to block sun/glare

 

I've got 2 more switches to add, but don't know where to put them..

 

Seen a guy built a switch holder that fit in the flip down fuse box cover, lower left of the dash...

 

Got a link?

 

On my phone right now, don't remember the thread, sorry.
I do remember he could close it with the switches in place...
I'm sure you could figure something out. ..

 

Tomorrow I will be rebuilding my brake calipers.. This video pretty well explains it.
https://youtu.be/qoQlAW4DPnA

• $87 Hawk Performance HB490Y.665 LTS Light Truck and SUV Street Brake Pads
  Hawk Performance HB490Y.665 LTS Brake Pad
• $9 Prestone AS401 DOT 3 Synthetic Brake Fluid - 32 oz.
  Prestone AS401 DOT 3 Synthetic Brake Fluid - 32 oz.
• $8 Carlson Quality Brake Parts 14023 Guide Pin Kit
  2 of Carlson Quality Brake Parts 14023 Guide Pin Kit
• $11 Centric Parts 143.44074 Caliper Kit
  2 of Centric Parts 143.44074 Caliper Kit

 

Where my switch pro switches are is a good spot

 

My phone goes there rather than in my hand.

 

Got my brakes done.. Pissed a lot of fluid out the passenger side and think there's still some air in the system.
This can of brake fluid has 2x as much as the normal looking can, at least by weight, and was $1 more (2/$6) than the normal (2/$5).


I'm not sure what was up but the outside pads are far less worn than the inside pads..
Driver side (the one pad is darker because I used it as a spacer, probably covered in brake fluid):

Passenger side:

 

Have you posted any more on the hammock stand?
Did you do 2 legs per side or 3?

Ken in NC

 

No, I don't think I have posted anymore about it. The new stand is the Metal 2 leg stand like the Meck stand, my old one is a 3 leg wooden turtle dog stand.

 

Ok, I'll look at the Meck stand design.
Thanks

EDIT:
Nice stand design.

 

@Sandman614
The pipes that hold the ridge pole and the down poles. Are they off the shelf items?

 

The connector pieces I got online, but you might be able to find them in a store..I don't know which store to suggest

1 3/8 Open L
One pipe slides through
http://tarps.com/fittings2.htm