OE Tonneau Cover P/N.

Anyone have a P/N for this peice from my Tonneau? I can't find a good assembly diagram anywhere. Drivers side. Thanks in advance!

 

If it is for the right side of the tonneau 64917-04010. This is the smaller of the two seals on the fold closest to the tail gate. I don't know the number for the left side. It was $25 approximately

 

Thanks I'll cross reference that number. The bastard broke off when I took my cover off. I ordered what I though was the correct part but I have to return it because it wasn't even close.

 

I can't help but just wanted to say thanks because I just got a good deal on a factory tonneau cover and the passenger side was broke. I'm going to try and super glue it for now but want to replace it and I couldn't find the part number either.

 

This is for the passenger side, but since you have you rubber piece this part number will work. You can remove the rubber with a torx bit in the center if you push the rubber to the side.

 

64915-04010 - Front Joint, RH
64916-04010 - Front Joint, LH
64917-04010 - Rear Joint, RH
64918-04010 - Rear Joint, LH

Jeff

 

What I did...gorilla glue. Seems to be holding pretty good.

 

This just happened to me so this is exactly what I was looking for.

 

Since there is a thread on P/N does anyone know the part number for the bolts where the cover locks in place I think it's about 6 of them. Thanks in advance

 

6 or 12?

 

I think it's 12. From my measurements, these screws are countersunk M6 25mm pitch 1.00. If you want to save yourself $30, you can get them from the hardware store.

 

That's not the one I need. Need the ones that go by the bed rails

 

Maybe you should take a picture of the area in your bed so I can better understand what you are looking for. These are the bolts that hold the pins into the side rails.

 

So those are the ones that clip into the locks? This is my old Tonneau I had on my "old" truck I took it off but my QS that I have now I need to trim the plastic pieces and add the bolts so it can lock in and a few other pieces so I can add it to my QS

 

Piece I gotta cut/trim

 

I think it's

69391 & 69415 plus those screws 64949

 

https://www.tacomaworld.com/threads/missing-hardware-for-oem-trifold-2016.483589/#post-14807980

See post #3. That's all the factory parts to make the tonneau cover work, minus the bolt, if all you have is just the cover. Still gotta cut your own rails.

 

What area do you live in will sell you my factory cover for 350.00

 

I'm looking for this part, 64918-04010 - Rear Joint, LH.

 

I could even make the right side work if need be