Orange County CAF's: up to no good

Sounds like we are having similar issues today. I am now off to o'rielly

 

c-clamps work in a pinch

 

No

 

And back to Home Depot because one bolt ended up being too short...

 

Is this going to be too close to the boot? And will it cause issues? I few like it will.


That's the closest 3/8 bolt I can get. This is a 3" bolt. I'm fairly certain a 2 1/2" bolt would be too small

 

Uhh there's no way a hacksaw is fitting in there. Idk if I can even get the washer and nut on there

 

sawzall w/ long metal blade might work. I have one you can borrow.

 

Damn. That sucks royally. I'll get a measurement for you today on the ones that I have.

 

Stop with the bolts. Just weld them on.

 

Absolutely, positively don't try to cut it off while it's in there. Measure how much needs to be cut. Pull the bolt out, thread the nut on, cut off the excess and then unthread the nut to clean the threads up. Also you may need what's commonly called a "Jam nut" or a "Half nut" they are just nuts that are shorter than usual nuts and might be necessary to clear the boot.

 

Not sure if you already answered this, but what's up with the sharktooth cuts?

You don't seem to have the best luck.....with anything really.

 

I am now headed to a place called dirty parts

 

Ya wasn't going to cut it in there. I'm pretty positive I'm going to need the jam nut. I cannot get this stupid thing on

 

This is at the place. I think I am going to like it here

 

He didn't want to buy the vinyl ones so he just made his own.

He said shipping was too much

 

Note to self....don't do mods with Brain @uhplifted he takes too long

 

I have one too if Brian needs it.

 

I'm done with these fucking skids. LCA skids for sale. $100