What have you done to your Tacoma today? 1st Gen Edition

My favorite bumper! Even Raptor lined it. I have the TG sliders & rear TG bumper too. But on those I used self etching primer and rattle canned matte black. Easier to touch up that way.

 

i already said i liked the hoops too

 

16" Method off-road racing Wheels and General Grabbers

 

Red Letters FTW!

 

They were decent, maybe a little exaggerated.

But they're also gone now so it doesn't matter.

 

Holy crap. There's so much want right now.

I'm deliberating on getting a 3rd gen 4Runner because my daughter is getting too big for the rear of my xtra cab. I'll PM you with a price question after I sleep on it.

 

If I took off my steering rack and moved my steering wheel is that going to cause any serious problems when I install it again ? Or should I be able to line it up with the linkage and be ready to roll ? I already got a new clock spring so I'm ready for that

 

Brand name and model?
Or is this also the trail gear low profile?

 

Sounds good man. It's got ome 883s up front with adjustable 5100s, new stock height shocks and coils in the rear with a 1.5" spacer, airbags for towing, 32" bfg all terains, 231mm tundra brakes, new drums, shoes, axles seals, wheel bearings in the rear and still lots more haha

 

its the same one

 

Added a 4Runner 2nd/3rd gen oem roof rack from the junk yard. 3rd gen crossbars (4 vs 3 and wider) on 2nd gen rails (longer).

 

might just need more pressure...it should lock into place when it gets to the right spot.

 

I walked away from it for a little while and got out of the heat. When I went back to it, I found the clips were off by just a bit and it was keeping it from lining up. Got it on in seconds after that

 

Did you mount yours using torque screws?

 

Yeah it's trail gear low profile. You can get it pretty cheap on one of the sales this summer, or at least free shipping.


I had a guy bend and weld some hoops on mine when I had it.

 

There's your problem. Bad wheel choice. Not design wise but filiment. Those sit in much further then even our stock wheels. Spacers will be the way to go and wont even get them out super far. Should be fine with 1.25" spacers

 

No, we used stainless steel bolts w/nylon lock nuts.

 

Got it painted today now just have to order some flush mount pods and a hoop

 

Are these the ones?

Callahan Brake Parts CCK11208 FRONT OE [2] Calipers + [2] Drilled/Slotted Rotors + Quiet Low Dust [4] Ceramic Pads Kit

https://www.amazon.com/gp/product/B00EOBMFAY/ref=as_li_tl?ie=UTF8

 

Those are the ones i run.