What Have You Done To Your 2nd Gen Tacoma Today?

Want to retire to Arizona but refuse to live anywhere near the valley.

 

I got this one, then just ran a wire up front to my Aux fuse panel in my engine bay and the other end to chassis.

https://www.amazon.com/Cllena-Charg...&redirect=true&ref_=oh_aui_detailpage_o03_s00

 

I bought the exact same lift (except I have SPC UCAs) and I just installed it. You won't be disappointed.

 

Newest vid posted! Thanks to @NKYTaco for this vid's outro image at the end!

https://www.youtube.com/watch?v=kMLObqZBRhQ

 

Have an extra set of steps or rack laying around?

 

Good to hear. Hoping to keep stock uca's


...for now anyway

 

I'll second that. Easy install too.

 

Gave her a bath

 

I just chopped my exhaust just behind the rear differentiated and the sound seems to have gotten much throatier, not sure if it's just because the pipe opening is closer to under the cab, does anybody else have this sound change?

 

When I assert dominance and prove my manhood

 

What black did you use? I really like the sheen

 

I needed some additional rearward lighting to go with my flush mount bumper lights. The bumper lights are great or down low lighting but I need some higher up or loading and unloading the 4wlr in the dark. I fabbed up a couple of brackets, mounted and adjusted the lights, and tied them inwith the bumper lights. The driver's side is supposed to be a dual mount for a cb antenna also but I think I'm going to make another like the passenger side and move the antenna to the front we'll see. They look kinda out in the open but should be protected when I get a soft top.

 

@Casper66 my only suggestion with those lights is to take them apart and put a small bead of silicon around the lip where the glass is, I'm running the same manufacturer as my ditch lights and they started to accumulate water on the inside. Very nice set up by the way.

 

Thank you sir. I have the same lights as fogs and so far no misture but will deffinately keep an eye on them and it's nice to know they are serviceable like that. They're a pretty decent light for the price. Now on to making bed stiffeners

 

Been anxious to start a build and post in this thread for some time. Picked up this apex rack from all pro and a cvt mt Shasta tent from a member on here.

 

Nice setup great truck

 

Dammit, I do. Just took off some steps off an access cab but threw them in the trash. They weren't in the greatest condition.

 

B&m trans cooler with raybestos inline magnetic filter. Also did a drain and fill. I'm going to run it as is for like 10k and do a pan drop, clean and fill. Anyone know if I can reuse the gasket?
I removed the stock cooler and used half of the stock connectors and mount points.

 

Fuck.... Grill is getting kinda busy...

 

If you're gonna go through the trouble of dropping the pan, you might as well get a new gasket to save yourself a potential headache.