What Have You Done To Your 3rd Gen Today?

I know the only one to me that is better than the inferno... It also won't fade like any red or burnt orange paint will..

 

Yep

 

@mpatrick

I finally got my rigid scene lights hooked up. Two each side and two more in the back with everything running up and into the switchpro. They have good output, but the long daylight hours prevent me from any night shots until morning.

 

So often I'll walk out to it parked like that and the person next to it will be parked right up on me.
Obliviots. You can't win.

 

If I'm going to be stuck with this Tacoma till I die, damn right I want it Line-X'ed. Tired of trying to keep this black clean now.

My brother has a black car but it being dirty don't bother him.

 

Go for it!

It will be way cool and quite a tough looking truck.

 

KB Voodoo short bed with a prinsu rack on top.

 

Thanks, beautiful!

 

Thanks! I'm a big fan of how it turned out!

 

I might have to grab one of those someday!

 

And you can get it in most any color you want. I would like either matte black or a dark battleship gray, like this truck.

 

Do you have a ballpark estimate for how much it weighs without anything loaded onto it?

 

blew
My
Load

 

Before and after shots 245/75 to 265/75/16 Toyo at2. Leveled out spot on with the 5100's at the 3rd notch and 1" block. The 1.25" spacers give it that extra touch!!! Also adding my Rad Industries grill and LED lights today!

 

Your setup....
Reverse light cutouts: No
Did you get the parking sensor hole cutouts?
Swing arm tire mount: Yes
Swing arm hi-lift mount: Yes
Did you get the swing arm fold down camp table?
Dual jerry can holder: Yes
Did you get the factory reverse camera relocation mount?
Did you get the BSM support cutouts?

Any help with the above, please?

I'm looking at ordering without light cutouts, with parking sensor cutouts, with swing arm tire mount, with highlift mount, with camp table, with single rotopax mount, with camera relocation mount, and with BSM cutouts. Curious how you like it and how all the cutouts are working for you. Thanks!

 

Where did you get those engine cover decals?i just painted mine like an amateur and it sucks.

 

Your looking at my exact set up but with a gas can variation. I've got the C4 overland bumper with back up and bsm sensors the spare tire swing out with hi-lift ,jerry can (steel so somebody can't poke it with a screwdriver) and table . Had to have the camera relocate though.. I absolutely love the table but I have to see through it . I am going to wrap it (table) so it doesn't show as much wear. Would do it again.

 

@rrentrop

 

It's the 40" cut out option from Prinsu, I've got a Morimoto X-Torch bar basically ready to go up just gotta find the time to throw it up and wire it, and find some security screws for it