1 inch block equivalent to?

Rear setting is set to full botch... front is set to zero.

 

Did you get the numbers figured out yet?

 

Took the blocks off and its now leveled. The block was 1 degree angle, not sure if that plays a factor..

 

I've got 5100's at second from the top and stock coils in the front and 5100's and 1" rear block. After 2 trips and 500 miles it settled to less than 1/2" higher in rear! Loaded with gear on a trail! Perfect!

 

I put 265's on it and I get tiny binding/rubbing on crazy articulation on some trails on driver side. I'll be doing the wheelers driver shim.

I've also got a cbi hidden winch bracket with a smittybilt x20 10k and a pelfrey ifs steel skid. In these pix!

Got @shmellfab sliders going on in the next couple of days too. I'll post some good pix once they are on!

 

Did OP ever surrender his truck?

Math isnt OP's strong suit I suppose.