Oregon Racks Mt.Hood low profile bed rack

That we are not 100% sure yet. It has not been verified yet.

Do you have a specific model tonneau cover in mind?

 

Damn it. Literally 5 days after i spend 10+ hours building my own rack... I woulda saved my sanity and bought this.





@vrun22 buy this

 

What do the tonneau cover brackets do? Also running factory third gen tacoma tonneau

 

Interested for sure! Couple questions though... is price with powdercoat? Is the bedrack a mid height setup? And also what is total length on the bedrack for short bed? Have a Mt. Shasta to mount up and need a rack that takes up most of the bed and extends longer than the mounting rails, was going to anchor it a little irreverently since it will extend past. Thanks

 

Allows you to run our bed rack with the tonneau cover still on, and allowing you to keep your stuff still protected still.

 

The price is powder coated with stainless steel hardware! And yes, a mid height rack. It sits 10" off of the top of the bed rails to the top of the bed rack/load bars.

They are only as long as the bed rail slides but, you or we can make an adapter bracket to allow you to move the rear upright fritter back.

 

You list load bars and bed racks for both short bed and long bed. Perhaps a better explanation regarding their differences would help clear future confusion. The distinction is not entirely clear since you only show pictures for one "rack". Not even sure if the picture is the bed rack or load bar since a bed rack has 1x3 extruded aluminum t-slot rail.

 

I'd say Option 1 & 2 are what's shown in the photos posted. Option 3 & 4 is what's shown on his website http://oregonracks.wixsite.com/oregonracks/products

 

G4 elite

 

To clarify, there's approx. a 30 lb difference in weight between the steel and aluminium versions? If so, put me down for an Option 3 in aluminium.

Also what's the length on the 1"X3" t-slot extruded aluminum bars on the bed racks?

 

Both the bed rack and load bars are the same uprights. The only difference is the bed racks come with the extruded t-slots. Our site shows the old style rack and will be updated soon!

 

If you can, shoot us some pictures of the outside and the inside where it mounts.

 

Roughly yes, I will know exact weight once I get the aluminum version back from laser and forming.

The rack will be as long as your bed rail slides.

 

Ok then when you post pictures of the brackets you should also post some of the bed racks so that everyone is fully aware of the difference as stated above by someone else. Visual is best, so words aren't misunderstood. Look forward to getting one though.

 

#NWexpo is aluminum powder coated?

 

its pouring right now but I will when I can. one other question. is there a why to mount tools, rotopax, etc with a rtt installed?

 

Yes, absolutely! All racks and load bars come powder coated.

 

Yes, with the bed rack, it comes with 1"X3" t-slot extruded aluminum which will allow you to mount various things.

 

Absolutely will do. We don't want any confusion at all. We appreciate the feedback everyone!

 

Put me down for a 10" aluminum rack that will secure an RTT, plz.